7-Way Recommendation for a 2009 Ford E-350 Van

Question

Question:

Item 118261 doesnt matchup eith my2009 E350 van. I have two four pin connectors with three or four terminals in each, one side being male and the other female. I could send a photo. What is your return policy?

asked by: Rocky

0

Expert Reply:

The connectors that the # 118261 is designed to fit should look like the picture that I attached. It is possible that you haven't found the correct harnesses on your 2009 Ford E-350 Van. The correct harness will be under the rear of the van inside the driver's side frame rail. See attached pic.

I attached a link to our returns policy page as well.

expert reply by: Jameson C

0

click to enlarge

Answer 1

The first place that I recommend checking when you lose power to something would be your fuse box. A blown fuse can cause the power to not reach your brake controller. If your fuses look okay then it might be easier to find a wire that is connected…

view full answer...

Answer 2

Wiring for your 2011 Thor Majestic 23A on Ford E-350 Chassis will depend on whether or not you have the factory tow package/ports, which it sounds like you do. For a 7-way you would need the T-One Vehicle Wiring Harness for Factory Tow Package -…

view full answer...

Answer 3

The cover we offer that will fit your 16 foot long trailer the best and offer the best protection is the Adco SFS AquaShed Cover #290-46004 which fits trailers that are between 14 and 16 feet in length. It also provides the best protection available…

view full answer...

Answer 4

The connectors you have found are not confirmed to be for the trailer wiring and we don't have any wiring harness that is a fit for what you described. Because you don't have the factory trailer wiring, I recommend starting with the T-One…

view full answer...

Answer 5

It sounds like your 2011 Ford E-250 is equipped with the towing package that Ford designates as the Class I tow package for the van. In this case there is a connector for the 16-pin plug on the harness but not for the 4-pin. If this is what you have,…

view full answer...

Answer 6

The Buyers Products 2" Multi-Fit Hitch Receiver For Ford/GM with Cutaway Service Bodies #3371801401 is 21.2" Deep. The height measurement you saw of 9" is from the top of the mounting bracket to the top of the receiver. The overall…

view full answer...

Answer 7

The Adco SFS AquaShed Cover for Bumper Pull Trailer - Up to 16' Long - Gray #290-46004 would work for your 7' x 16' enclosed trailer, but there is a chance that it doesn't completely cover the bottom of the wheels and tires since it…

view full answer...

Answer 8

We can help you with a 4-pole flat trailer wiring harness for your 2012 Ford E-350 van. All types of wiring kits are shown on the linked page. These include products for vans equipped with no factory wiring, vans with a factory 4-pole set-up and vans…

view full answer...

Answer 9

On you 2011 Ford E-350 Van, you will need to get the brake light signal off the cold side of your brake light switch. Using a tester, like #PTW2993, you will find the wire on the switch that is only energized when the brake pedal is being pressed.…

view full answer...

Answer 10

I would not recommend to replace any of the relays on the 2009 Saturn Sky. If you are having a wiring problem and the relay is activating, it is doing that to protect your vehicles wiring system. You do not want to change the relay and allow more…

view full answer...

Answer 11

The Buyers Products 2" Hitch Receiver For GM Express/Savana with Cutaway Chassis part #3371801102 will fit the frame just fine on a Chevy 3500 Shuttle Bus but the bumper is where things can cause problems as not all hang down the same amount.…

view full answer...

Answer 12

I recommend looking at the Buyers Products 2" Multi-Fit Hitch Receiver For Ford/GM with Cutaway Service Bodies #3371801401 for your 2007 E-350 Chassis. This receiver is designed to fit frames that are 42" wide to the outside of the frame…

view full answer...