Single RV Switch Faceplate - White

Video Transcript for Review of JR Products Wiring Accessories - Switch Faceplate - 37212845

Hey everyone. I'm Ellen here at etrailer.com, and today we're going to be taking a look at the RV switch face plate. This is going to make a nice little home for your switch to seat into and have a completed look, or a finished look for the wall. Just comes with the face plate, it doesn't come with any hardware, so you will have to provide that on your own. It's going to kind of depend on what surface you're mounting this to what material it is, as far as what screws are going to be the best. So it's kind of up to you there to provide that.

You can see, have a nice kind of bevel to it and then it angles away from the wall, so it gives it a nice look. It's kind of a raised Ridge going around the perimeter here.As far as size overall, it's about one and 5/8 inch across by about two and 3/4 inches wide. The cutout is just barely over a half inch, so about a 9/16 and then the other direction, a one and 1/8 inch. So any switch that's one and 1/8 inch by 9/16 should work pretty well for this guy. Comes in white, a distance between the mounting holes, center to center it's about two and 1/8 inch.

And the diameter of those is about 3/16. So it's made in the USA, and that's about all there is to it for our look at the single RV switch face plate. I hope this video has been helpful in deciding if this is the right piece for you. If not, we do have a lot of other options here at etrailer.com, so check them out. Thanks for watching..