bing tracking image

Filter Questions and Answers:

reset filter

Expert Answers about Dodge Sprinter


  • Installation of Ultra-Fab Power Twin II Electric Stabilizer UF39-941707 on Dodge Sprinter RV
  • You can install the Ultra-Fab Power Twin II Electric Stabilizer # UF39-941707 on your Sprinter-based RV as long as 1) you have the required 24-inches of frame access needed for the mounting brackets and 2) the frame width is between 42- and 77-inches. This dual motor kit includes a hand crank for manual operation and a power switch. You can use duplex wire # 10-2-1 (sold by the foot) and butt connectors # DW05745-10 to make your electrical connections.
    view full answer...

  • Do the Carr Custom-Fit Side Steps Super Hoop Fold Up to the Vehicle When Not In Use
  • Yes. A step like the Carr Custom-Fit Side Step - Hoop II - Black Powder Coated Aluminum - 7" Step - Qty 1 Item # CARR104501-1 would have some adjustment to allow you to fold up when not in use and provide a large, flat, non-skid surface for you to get into and out of your Dodge Sprinter. These are the only style of steps available to fit your 2006 Dodge Sprinter van.
    view full answer...

  • 2006 Dodge Sprinter Trailer Hitch and Spare Tire Compatibility
  • We have two hitch receiver options compatible with your 2006 Dodge Sprinter, however both options do require relocating the spare tire. The compatible hitch receivers are the Curt # 13250 you referenced and the Curt # 14250 which has a higher capacity rating. You may want to consider the Roadmaster Spare Tire Carrier # RM-195125 which won't allow for trailer towing but will allow for flat towing or use of an accessory like a bike rack or cargo carrier.
    view full answer...

  • Will Rola Swinging Enclosed Cargo Carrier Clear Rear Mounted Spare Tire On 2004 Dodge Sprinter
  • You can take a quick measurement to see if the Rola Swinging Enclosed Cargo Carrier, part # 59109 will clear your spare tire. You will need a tape measure and a straight edge like a yardstick or a dowel. Place the straight edge vertically against the back of the spare tire, letting it extend below the trailer hitch receiver opening. Then measure from the center of the hitch pin to the straight edge. This will give you the distance you need to clear the spare tire. The # 59109 has a...
    view full answer...

  • Trailer Hitch Rated for 10K Towing for a 2003 Dodge Sprinter with 140 inch Wheelbase and DRW
  • The Curt Class IV Trailer Hitch # 14250 will only fit if your 2003 sprinter has the 140 inch Wheelbase with Single Rear Wheels. Since you have a 140 inch Wheelbase with Dual Rear Wheels the next best option is the Curt Class III Trailer Hitch # 13265 which is rated for 6K Towing/600 lbs Tongue but then jumps up to 10K Towing/1K Tongue when used with a weight distribution (WD) system like the Equal-i-zer w/ 4-Point Sway Control # EQ37120ET. Please note that your Sprinter must be rated for...
    view full answer...

  • Trailer Wiring for 2005 Dodge Sprinter
  • A new harness may be the solution, but you may not need to spend money to fix the problem of your turn signals not working with the trailer wiring on your 2005 Dodge Sprinter; what you can do first is a bit of troubleshooting to find out. In order to determine the specific problem, you will need to use a circuit tester such as # PTW2993 to test the connector on your Sprinter after disconnecting it from your trailer. Check the wiring going into your harness from your taillights to see if...
    view full answer...

  • Will Curt Bumper Mount Trailer Hitch # E-100 Fit a 4-1/4 Inch Bumper on a Starcraft Starsteam 24QB
  • The Curt hitch # E-100 needs a 4 inch square continuous welded steel bumper to install safely. If by removing the decorative trim, you are left with a 4 inch square continuous welded steel bumper, then this hitch will work for you. Be sure to check the owners manual to determine if the bumper can be used for this application. the safest option is to go with a frame mount hitch. I have included a link to the options for you. The most popular is Curt hitch # 13703 because it fits a wide...
    view full answer...

  • Compatibility of the Curt Class IV Hitch # 14250 on a 2006 Dodge Sprinter Van w/ OEM Step Bumper
  • The Curt Class IV Trailer Hitch Receiver, # 14250, will fit your 2006 Dodge Sprinter w/ OEM step bumper after some minor modification to the installation hardware. The Curt hitch instructions state that for the factory step bumper models, the corner of the 1/4 inch spacer plates, that are included with the hitch, will have to be broken off to allow the reinstallation of the step bumper. There will be no modification to the actual bumper of the Dodge Sprinter.
    view full answer...

  • Replacement Gear Box and Linkage for Kwikee Step with 151364 Linkage
  • We've checked with Kwikee in the past for the linkage arm 151364 and the correct replacement is the part # LC379649. For the entire gear box and linkage the correct part number is the # LC379160 that you mentioned.
    view full answer...

  • Recommended Awning For A 2006 Dodge Sprinter Van
  • Awnings like the Solera 12V XL Power RV Awning # LCV000334919-362241 aren't really intended for use on the side of a sprinter van but if you could still technically install it on your 2006 Dodge Sprinter. The arms of the awning will need to be bolted into studs and needs to sit on a flat surface so you'll most likely need to do a lot of modification to your van to safely install this. Typically most van owners use the Thule HideAway Awning # TH490011, as it's specifically designed for...
    view full answer...

  • Heavy-Duty Cargo Carrier For Class C Motorhome
  • We do have an option for a hitch cargo carrier that will work for your Class C motorhome, is rated for 500 lbs, and is able to carry your gear. While there isn't one that will specifically state "Acceptable for Class C" what you will need is a cargo carrier with a fixed shank and not a foldable carrier: - 24 x 60 Reese Cargo Carrier for 2" Hitches - Steel - 500 lbs # 63153 The Reese # 63153 is the heaviest-duty carrier with inside dimensions of 60" long x 24" wide x 5-1/2" deep so it...
    view full answer...

  • Can Size 225/75-16 Sized Tire Chains be Used for Size 235/85-16 Tires?
  • I found an answer that will work. Unfortunately, the Konig Standard Snow Tire Chains - Diamond Pattern # TH01571245 cannot be modified without undermining the integrity/safety of the tire chains to fit a 235/85-16 tire. However, we do sell some tire chains with that size. I recommend the Titan Chain Snow Tire Chains w/ Cams # TC2821CAM. The Titan chains involve a manual installation with cam tightening for a tight, secure fit. They are also the great economic option. If you need more than...
    view full answer...

  • Are SumoSprings Designed to be Taller than Suspension Bumps Stops
  • The SumoSprings Solo Custom Helper Springs # SSF-401-54 are intentionally designed to be taller than the bump stops on the suspension of your vehicle. This is so they engage sooner and provide support. Bump stops aren't designed for adding support so much as they are for preventing bottoming out. These will help noticeably with impacts felt from pot holes or sudden impacts.
    view full answer...

  • Will The Draw Tite 75210 Fit Vehicles With The Factory Step Bumper
  • I apologize for any confusion. With these 2005 Sprinters there are many different versions, and sometime our vehicle listing can get a little crowded/confusing. The draw tite hitch # 75210 will be a good fit for your 2005 Sprinter 158" wheelbase SRW with the factory step bumper. We have confirmed this with the folks at Draw-tite, as well as with several of our customers, who have successfully installed the hitch on vehicles with the step bumper.
    view full answer...

  • Will SuperSprings Suspension Stabilizer Work On 2008 Dodge Sprinter That Has Timbrens
  • The SuperSprings Suspension Stabilizer # SSA11MTKT is designed to work with your OEM leaf springs on your 2008 Sprinter. As long as the installation of the # SSA11MTKT does not interfere with the sway bar or the Timbrens, you can use this system.
    view full answer...

  • Can a Trailer Hitch Mount Bike Rack and Cargo Carrier be Used at the Same Time
  • With the 24x60 Railed Cargo Carrier, # 63153, installed in the trailer hitch, you will not be able to install anything else in the hitch and nothing can be installed in the tubing in the cargo carrier. What you could do is use the Curt Dual 2 Inch Receiver Tube Adapter, # D-192. However, the bikes will be hanging above the cargo carrier, limiting the amount of space on the carrier. Also this adapter/extension has a tongue weight rating of 350 pounds. This means that the cargo carrier,...
    view full answer...

  • Which Trailer Hitches Fit a 2006 Dodge or Freightliner Sprinter without a Step Bumper
  • There are 5 versions of the 2006 Dodge/Freightliner Sprinter so to determine if there is a hitch that will fit we have to look at which specific model you have. If you have the 118 inch wheelbase, single rear wheel model you can use # 13250 or # 14250 If you have the 140 inch wheelbase, single rear wheel model you can use the same Curt hitches above as well as # 75210 If you have the 140 inch wheelbase, dual rear wheel model you can use # 13265 If you have the 158 inch wheelbase, single...
    view full answer...

  • Will the Thule Elite Van XT 2 Bike Rack Fit on a 2005 Dodge Sprinter Van?
  • I do have a good solution for you, however. I confirmed with Thule that the Thule Elite Van XT 2 Bike Rack for Sprinter Rear Door # TH302043 will not fit a 2005 Dodge Sprinter Van. However, the next best solution is to use a hitch and a hitch-mounted bike carrier. For the bike rack, I recommend the Kuat Sherpa 2.0 Bike Rack for 2 Bikes - 2" Hitches # SH22G along with the Kuat Pivot 2 Swing Away Hitch Extender for Bike Racks # PVP20B. The great thing about the Kuat Sherpa 2.0 with the Pivot...
    view full answer...

  • Will MB Sturgis Horizontal 2-Stage Propane Regulator Work With Class B Motorhome
  • The MB Sturgis Horizontal 2-Stage Propane Regulator # 108221 is an excellent choice for a propane regulator! This works directly with your propane pigtail if you have a 1/4" Male NPT fitting. If you have the inverted fitting then you'll need the Adapter # 37207-30035 for the inlet side of the regulator.
    view full answer...

  • Can Front Mount Hitch Receiver Be Installed on a 2006 Dodge Sprinter
  • For your application you'll need to look at universal hitches like the Weld-On Draw-Tite Ultra Frame Service Body Trailer Hitch Receiver # 41990-07 since there aren't any custom fit hitches for your 2006 Dodge Sprinter. We haven't installed this before so you'll have to check the fitment with your vehicle but it's the best option we have to offer.
    view full answer...