Compatibility of the Curt Class IV Hitch # 14250 on a 2006 Dodge Sprinter Van w/ OEM Step Bumper
Question:
2006 Dodge Sprinter 2500 140inch wb, single rear wheels, factory rear step bumper. Need to know which hitch will fit and/or if I have to remove or modify step bumper. Dont mind a little cutting or drilling but I dont weld.
asked by: Bob
Expert Reply:
The Curt Class IV Trailer Hitch Receiver, # 14250, will fit your 2006 Dodge Sprinter w/ OEM step bumper after some minor modification to the installation hardware.
The Curt hitch instructions state that for the factory step bumper models, the corner of the 1/4 inch spacer plates, that are included with the hitch, will have to be broken off to allow the reinstallation of the step bumper.
There will be no modification to the actual bumper of the Dodge Sprinter.
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class IV - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class IV
- 1000 lbs TW
- 10000 lbs GTW
- 12000 lbs WD GTW
- 2 Inch Hitch
- 1200 lbs WD TW
- Visible Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Replacement 7 inch Monitor for Furrion Vision S system FOS07TAEN
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Trailer Wiring for 2006 Dodge Sprinter for Taillight Functions of Trailer
- Q&A: Recommended 7-Way Trailer Connector for a 2004 Dodge Sprinter Van
- Article: Trailer Wiring Diagrams
- Q&A: Upgrade for Dexter Curved Equalizer 13-142
- Q&A: Adding an In-Line Fuse to Maxxair Deluxe
- Q&A: Hitch Receiver Needed to Install on Inside Frame of a 2003 Freightliner Sprinter
- Q&A: Replacement Hub and Rotor Assembly with 5 on 4-1/2 Bolt Pattern for 3,500 Pound Trailer Axle
- Article: Stability Control for Heavy Duty Vehicles
- Article: RV Sway Control, Stabilization, and Suspension Enhancement
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Flat Towing Package for 1998-2006 Jeep Wrangler