Great question!
The hitch receiver on motorhomes tends to sit further away from the rear axle than it does on a standard passenger vehicle which is why the weight rating reduction applies to both Off-Road and RV use for the Yakima OnRamp # Y36FR. Technically you could still use this on a motorhome but if any damage were to occur it wouldn't be covered under warranty.
For your application I recommend using the Hollywood Racks RV Rider Bike Rack # HLY64FR which can hold up to 80 lb bikes... view full answer...
I went out to the warehouse to measure the round anchors in Mounting Hardware # TWPH2770. The bases of the round anchors are 2 inches in diameter. The part that goes into a hole is 1/2 inch in diameter so the hole it goes into would have to be smaller than that for a snug fit. view full answer...
I checked with our vendor and the etrailer item # e98856 has a 350 lbs tongue weight capacity when installed on a 2019 Jeep Wrangler JL.
The Draw-Tite item # DT78MR has the highest available tongue weight capacity at 675 lbs. I highly recommend checking with your owner's manual or contacting a Jeep dealership to confirm what your Wrangler JL's actual tongue weight capacity is. The hitch manufacturer's, especially Draw-Tite, over-rate their hitches because they fit many different models... view full answer...
I would be happy to! One of the most reliable and easiest supplemental braking systems to install is the Blue Ox Patriot Radio Frequency, Portable Braking System item # BLU37TR. This is a proportional braking system which means it stops or slows your Jeep with the same force as you are braking in your RV. This is the safest way to stop and it reduces wear and tear on both vehicles and towing components.
The Blue Ox Patriot item # BLU37TR is also a portable system which means you can use... view full answer...
Yes, it will if you are using a Demco base plate kit along with your Demco Commander tow bar! The Roadmaster Tow Defender Protective Screen for Towed Vehicles item # RM-4750 is compatible with this combination, however I have a better option.
The Sentry Deflector for Demco Tow Bars item # DM9523135 is a better rock guard compared to the Roadmaster option because it covers the front of the vehicle not the top of the tow bar. It is also a solid polyethylene shield instead of a nylon screen.
We... view full answer...
One of the most reliable and easiest supplemental braking systems to install is the Blue Ox Patriot Radio Frequency, Portable Braking System item # BLU37TR. This is a proportional braking system which means it stops or slows your Jeep down with the same force as you are braking in your RV. This is the safest way to stop and it reduces wear and tear on both vehicles and towing components.
The Blue Ox Patriot item # BLU37TR is also a portable system which means you can use it on your next... view full answer...
Yes, you will! For the Demco SBS Stay-IN-Play DUO item # SM99251 to function properly in your 2024 Jeep Wrangler 4xe you will need to use the Roadmaster Universal Stop Light Switch Kit item # RM-751000. It is required because your brake lights do not function when the Jeep is in the tow mode according to Roadmaster. view full answer...
Thanks for the part number! We have a couple of options to replace the brakes on a Dexter 3,500 lbs axle depending on whether you want the self adjusting brakes or the standard ones. I have listed both options below:
Self Adjusting - Dexter Nev-R-Adjust Electric Trailer Brake Kit - 10" - Left and Right Hand Assemblies - 3.5K item # 23-468-469. Sold as a pair you will need one per axle.
Standard Brakes - Dexter Electric Trailer Brake Assembly 10" - Left Hand - 3,500 lbs item # 23-26 and... view full answer...
I checked with Bestop and the Instatrunk Custom Cargo Area Storage Unit # B4270201 measures 11 inches high x 11 inches deep x 35 inches wide when installed in your 2010 Jeep Wrangler Unlimited. This will give you 2.7 cubic feet of storage space which is lockable; I've added a link to the install instructions for you to take a look at as well. view full answer...
To add a hitch to your 2023 Jeep Wrangler 4xe, I recommend the etrailer Hitch item # e98856. This hitch is custom fit and attaches directly to your Jeep's bumper with four included bolts. This hitch is one of the easiest to install on the market.
This is a class III hitch with a 2" receiver. It has a 3,500 lbs towing capacity and a 350 lbs maximum tongue weight. I have linked an installation video below.
If you are planning on towing you will also need a wiring harness item # 118786... view full answer...
The Dexter Trailer Hub and Drum Assembly # 84557UC3-EZ weighs 24 pounds.
The Dexter Nev-R-Adjust Electric Trailer Brake Kit # 23-468-469 has a total weight of around 20 pounds.
The Timbren Axle-Less Trailer Suspension System # ASR2000S02 weighs around 72 pounds total.
The TruRyde EZ Lube Spindle # TRU74FR weighs 6 pounds.
The etrailer.com Round Swivel Marine Jack # MJ-1200B has a weight of 15 pounds.
The Tekonsha Prodigy P3 Trailer Brake Controller # 90195 weighs in at just 1-1/2... view full answer...
The Dexter Trailer Hub and Drum Assembly # 84557UC3-EZ weighs 24 pounds for one hub assembly. This comes with 1 hub and drum assembly, including the bearings races, and seal. If you need two assemblies, you will just need to order 2.
I have attached a short video demonstration on this product that you can also check out. view full answer...
We have not had any feedback concerning the Derale Transmission Line Compression Fitting Kit # D13031 being prone to leak. If the outside diameter of your transmission line is 5/16" on your 1995 Jeep YJ then these fittings are going to work for you. To make certain there is no leaking what you can do is use liquid thread tape (Leak Lock) to seak the threads on the components expect for the one that secures the compression ring. You can also use standard thread tape, just make sure it is... view full answer...
I did some checking and the large bolt and the nuts that fit it on the Rampage Recovery Bumper with Swing Arm # RA88606 are 1-1/4"-7. That means 7 threads per inch so you would need 1-1/4 inch nuts with 7 threads per inch in the desired size to work with your application. view full answer...
We actually had the opportunity to install the Draw-Tite Max-Frame Trailer Hitch Receiver # 76021 on a 2018 Jeep Renegade Latitude and found from the ground to the top of the receiver tube is 10-1/4". Since this is a 2" receiver we can subtract 2-1/4" (the 1/4" is for the collar) which puts the bottom of the hitch around 8" above the ground. I have attached a photo and our installation video for you to check out.
If you let me know what you plan on using the trailer hitch for I'd be more... view full answer...
To add a hitch to your 2022 Jeep Compass, I recommend the etrailer Hitch item # e48AR. This hitch is custom fit and bolts to your Jeep with included hardware. I really like this hitch because the crosstube mounts behind your rear bumper cover leaving only the 2" receiver visible.
Since you are planning on towing you will also need a wiring harness item # C66BR and a ball mount kit item # C45534.
I also recommend using the No-Drill Mount Bracket item # 18136 and the item # C42CR to secure... view full answer...
The Tow Ready 2 Inch Hitch Ball, part # 63845, and the hitch ball # 19260 of the ball mount kit part # 989900 you have referenced needs to be torqued to 250 foot pounds.
The size of socket or wrench needed to tighten that would be a 1-1/2 inch and then for the diameter of the crowsfoot or wrench for holding the ball it would need to be 1-3/4 inch. view full answer...
Las cajas en las que enviamos nuestros enganches son de un tamaño estándar de 45 "de largo x 8" de alto x 23 "de ancho.
The boxes that we ship our hitches in are a standard size of 45" long x 8" tall x 23" wide. view full answer...
Yes, we do. To carry the Thule Hullavator item # TH898 on your 2021 Jeep Gladiator Sport, I recommend the roof rack by Rhino Rack and it includes the following parts:
Rhino-Rack Vortex Aero Crossbars - Aluminum - Black - 71" Long - Qty 2 item # RRVA180B-2
RLTP Leg Adapters for Rhino-Rack Vortex Aero Crossbars - Track Mount - Qty 4 item # RRVA-FK1-2
Rhino-Rack Roof Rack Legs - Gutter Mount - 4-5/16" Tall - Qty 4 item # RRRL110S5-2
These crossbars are 12" longer than the item # RRVA150B-2... view full answer...