Distance Between Mounting Holes On Curt Hitch C13048
Question:
Can you tell me the width center to center of the mounting holes on part # C13048?
asked by: Lucky
0
Expert Reply:
I spoke with my contact at Curt and the bolt holes from left to right on the Curt hitch part # C13048 are 36-5/8 inches apart.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class III
- 500 lbs TW
- 5000 lbs GTW
- 5500 lbs WD GTW
- 2 Inch Hitch
- 550 lbs WD TW
- Visible Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: Trailer Hitch
- Shop: Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Q&A: How do I Find Out if my 98 Jeep Grand Cherokee Came with the Factory Tow Package?
- Q&A: Will Curt Trailer Hitch Receiver C13065 Fit 2015 Jeep Grand Cherokee Altitude W/ Dual Exhaust?
- Q&A: What is a Concealed Cross Tube Trailer Hitch
- Q&A: 4-Pole Wiring for my 1995 Jeep Grand Cherokee
- Q&A: How to Install Trailer Wiring in a 1998 Jeep Grand Cherokee without Interior Access Panel
- Q&A: Will the Aftermarket Wire Harness Cause My Lamp Outage Sensor to Come On
- Q&A: Is Road Armor Equalizer Upgrade Better Than MORryde
- Article: My Trailer Hitch Doesn't Fit
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Rooftop Cargo Carriers
- Article: Using a Portable Generator on RV