Expert Answers about Ford Explorer

• Tekonsha Vehicle Wiring Harness For a 1996 Ford Explorer With Factory Trailer Wiring
• The Tekonsha Tow Package Wiring Harness # 118241 for your 1996 Ford Explorer will have 4 pins located inside the connector. The 4 pins are located on the side with the pin that is located a 3 o'clock from the connector. These pins will control both turn signals, brake lights and the trailer running lights, they do not have points for the license plate lights as well. You will not be able to move the connectors around as they would have to share 2 of the same pins. First be sure that you...
  view full answer...


• Is Towing Capacity Different for 2017 Ford Explorer With Aftermarket Trailer Hitch or OEM Hitch
• The actual trailer hitch itself isn't going to be something that affects the capacity (pulling power) or the suspension on your 2017 Ford Explorer. I took a look at the owner's manual, and no matter if you are using the OEM hitch (which I could not find any type of specs on in regards to its class or capacity), or the Draw-Tite Trailer Hitch # 76034 you are limited to a towing capacity of 2,000 lbs, 3,000 lbs (with the Class II Trailer Towing Package) or 5,000 lbs (with the Class III Trailer...
  view full answer...


• Does K-Source Back Up Camera KSVS-8 Include a Back Up Alarm
• I'm not sure what you mean by an alarm... The K-Source # KSVS-8 doesn't include anything that would beep as the vehicle is reversing but you could certainly add something like that if you wish. We carry several different reverse alarms that would sound a loud beep when the vehicle's shifted into reverse. I'd recommend part # PK41820, which has a 97 dB alarm. Installation would be simply, the alarm would mount behind the rear bumper somewhere with only two wires to install. The red wire...
  view full answer...


• Catalytic Converters for a 2000 Ford Explorer Limited with 5.0 Motor
• Without the O2 sensors in place the 2000 Ford Explorer would run poorly. You would need new ones if the old ones are shot. But one of my coworkers stated that the catalytic converter(s) likely have a clog which would cause the system to run too rich and ignite the fuel that is being dumped into the exhaust. So more than likely you will need to replace the catalytic converters. So it definitely sounds like you need new O2 sensors and new catalytic converters. It could be that the heat damaged...
  view full answer...


• Location of the Brake Control Wires on a 2002 Ford Explorer
• The wires for the brake controller on your 2002 Ford Explorer will be in one of two locations. They may be under the dash on the drivers side of the vehicle left of the steering column or behind the glove box on the passenger side. If your vehicle has a factory 7-Way connector, then there should be a port where you can plug in the wiring adapter, # 3035-P. The port may be white, black or gray. If your vehicle comes with a factory 4-Flat trailer connector, then you may or may not have that...
  view full answer...


• 1999 Ford Explorer Eddie Bauer Trailer Connector
• In my research, I wasn't able to find out definitively if all the Eddie Bauer Explorers included a trailer connector. Some 1999 models were equipped with a towing package which included the 4-pole trailer connector. What I read seemed to indicate that if the vehicle was equipped with the factory trailer hitch, it'll have the factory wiring. Determining how your particular vehicle is equipped would be very simple. Look behind the rear bumper on the passenger side of the vehicle for a round...
  view full answer...


• Axel and Wheel Modification of the VTG201 Viking Solutions Tilt and Go 2 Cart
• The Viking Solutions Tilt-N-Go II Hauler and Cargo Carrier for 2" Hitches, # 310-VTG002 is an import item supplied as a kit. Any modification such as replacing the axle with an extended version of, will need to be made by the purchaser as a custom fabrication.
  view full answer...


• Will Hopkins HM39524 Brake Buddy Select 3 Actuate Brakes Even Though Vehicle Isn't Running
• Although you won't have power brake assist with the vehicle off, the Brake Buddy Select 3, part # HM39524 will apply enough pressure to the brake pedal that the brakes will work just fine once the unit is installed and properly set up according to the installation instructions. You'll be able to remotely control the unit from the cab of the motorhome. I've linked to an install/demonstration video that you might find helpful.
  view full answer...


• Tow Dolly For 2017 Ford Explorer
• You absolutely can use a dolly like Demco Kar Kaddy X Tow Dolly w/ Disc Brakes - Tilt Bed Frame # DM9713093. The eZ-Latch surge coupler transmits braking signals so there is no need to buy a separate brake controller or 7-way plug. You are also going to need Demco Kar Kaddy Tow Dolly License Plate Bracket # DM39VR so you can tow safely and in DOT compliance. Additionally, the Demco Kar Daddy has a towing capacity of 4,800lbs and your 2017 Ford Explorer has a curb weight of 4,600lbs, be...
  view full answer...


• How to Determine if 2014 Ford Explorer Has Factory Tow Package
• The best way to determine if your Explorer is equipped with the tow package is to check with your Ford dealer. They should be able to run the VIN and be able to tell you exactly how the vehicle was equipped. I'm assuming you're needing the information to determine the towing capacity of your Explorer. I ran the provided VIN through a Ford VIN decoder, and found that your particular vehicle has the higher of the 2 listed towing capacities at 5000 lbs which would lead me to believe that...
  view full answer...


• Nut and Washer Material on the Convert-A-Ball Interchangeable Ball Set # 903B
• The nut and washer included with the Convert-A-Ball Interchangeable Ball Set, part # 903b are zinc plated steel. They are not stainless steel, like the rest of the assembly. I have included a link to a video about this interchangeable ball set for your reference.
  view full answer...


• Does Weight Distribution System for 2008 Ford Explorer Increase Towing Capacity
• The GCWR is the total allowable weight of your fully loaded 2008 Ford Explorer and travel trailer so the hitch weight (tongue weight) would not factor into that. If you looked in your owner's manual and are sure that your GCWR is 15,000 lbs, that would be the total weight that your loaded vehicle and trailer could weigh; additionally, tongue weight does not factor into payload capacity, and a weight distribution system does not factor into the tongue weight. What you need to do is make...
  view full answer...


• What is the Speed Rating of the Castle Rock 205/75R14 Trailer Tire
• My contact at Castle Rock confirmed that the tire and wheel combination # LHACKSJ211G has a speed rating of M which is 75 mph. You will want to make sure to not go over the weight capacity of this tire and wheel, which is 1,760 lbs per tire at 50 psi, or your trailer.
  view full answer...


• What is Max Wheelbase Size for Swagman Skaha Bike Rack
• Yes, the Swagman Skaha Bike Rack # S67SR works with bikes that have a wheelbase up to 50 inches.
  view full answer...


• Are Interchangeable Trailer Ball Kits from Convert-A-Ball Safe?
• The Convert-A-Ball Interchangeable Trailer Ball Kits are perfectly safe up to their 10K capacity, just as safe as a standard one-piece trailer ball, so you'll have no worries there. This is without a doubt the type of interchangeable ball I'd recommend. The side pin arrangement that Convert-A-Ball uses works great, and the pin actually features an o-ring on it to keep moisture and debris out. The # 904B kit you'd looked at is nickel plated, and over time the nickel plating can be worn...
  view full answer...


• How to Determine Which is the Transmission Cooler Return Line in 2003 Ford Explorer
• The method for determining which line is the return line is to: 1. Start engine while engine is cold 2. Put your transmission into Drive for no more than 10-15 seconds 3. Stop engine, remove keys 4. Identify oil return line by feeling both lines, the cooler of the two is the return line Sometimes the transmission itself will have markings to indicate the function of each connected line.
  view full answer...


• Function Of Vehicle to Vehicle Taillight Converter # 118158 When Towing Vehicle With Separate Wiring
• The instructions that are included with the Roadmaster 6-Diode Universal Wiring Kit, part # 154-792-118158, detail how to wire a separate towed vehicle from a separate motorhome. The # 118158 instructions show how to wire the converter that takes the combined signal from the motorhome and when it senses the pulse from the turn signal being used, sends that signal to the wire for the turn signal out of the converter and attached to the appropriate wire on the trailer. I have attached a...
  view full answer...


• Providing More Clearance Between 2001 Explorer and 14 Foot Boat Its Towing
• If you're towing the boat using a trailer ball installed directly into a hole on the bumper, and you're wanting to get more room between the trailer and the vehicle, a good alternative would be to install a frame mounted hitch like the Draw-Tite Class III Trailer Receiver Hitch, part # 70647. If you needed more extension, you could use a longer ball mount, like part # 80233. You'd also need the appropriately sized trailer ball, like # 19260 for a 1-7/8 inch ball or # 63845 for a 2 inch...
  view full answer...


• Will Derale Transmission Cooler For 2019 Ford Explorer Raise Towing Capacity
• There is nothing that can be done to raise the towing capacity of your 2019 Ford Explorer, it is set by Ford, and no aftermarket products, including a transmission cooler like the Derale Series 8000 Plate-Fin Transmission Cooler # D13503, will change that. A secondary transmission cooler (as well as oil cooler) is a supplemental aspect of your vehicle's performance, helping ensure a longer-lasting, more efficient cooling system, so that's the benefit of the # D13503, but upping your towing...
  view full answer...


• Should Brake Controller Port Under Dash of 2003 Ford Explorer Have Power at All Times
• One terminal on the brake controller port should have voltage at all times, one terminal is the brake light signal which will only have power when the pedal is pressed, one is ground, and the other is the output to the trailer. I have attached a picture of the Tekonsha Plug-In Wiring Adapter, # 3035-P, that is designed to plug into the port on your 2003 Ford Explorer. I recommend taking a look at this picture and compare it to the port that you have located to make sure it is the correct...
  view full answer...