Summer Starts Here - Save up to 70%
2-1/2" Round. Waterproof, incandescent trailer light serves as either a side marker light or a clearance light. Built-in reflex reflector. Premium bulb for long life. Recessed mount with grommet (sold separately). Accepts 2-prong plug. P2 rated.
Features:
Specs:
The waterproof construction of this light makes it ideal for use on trailers that may be submerged, like a boat trailer. The circuit board is sealed, which means that water will not damage the diodes or circuit board.
A P2-rated light produces a 45-degree angle of light to either side of its centerline for a total of 90 degrees of coverage. This beam pattern can be seen straight on, but it cannot be seen clearly from the side. So this type of light can be used as either a side marker light or a clearance light, but it cannot function as both. If you need both functions, then you must install 2 separate lights on your trailer - one as a front or rear clearance light and one as a side marker light.
Recessed-mount trailer lights install with a grommet, which is often sold separately. These lights extend past the trailer surface and require a hole for installation. If replacing a light, you can utilize the pre-existing hole. If installing a new light, you will need to cut a hole or use a mounting bracket (sold separately) to complete the installation.
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Today we're going to take a look at the Peterson trailer clearance or side marker light. In addition to being a light itself it also has a reflector, as you can see there, to have visibility even when we're not using our trailer and we don't have our lights on. It'll stay be visible even at night when the light shines on it.This is going to be a submersible light. It is an incandescent, so you might be able to see the bulb there from the side. It's just a single bulb design, and at the back we'll have our two prongs that we can connect to our wiring and get hooked up.With our plug in place, that'll give us our lighting functions. Our light function.
Turn the studio lights out so you can see just how bright that is, even in low-light. So not blindingly bright, just enough to make us visible at night. And this light is going to be P2 rated, so basically that means that from the front, we'll be able to see it until about a 45 degree angle. And then the light starts getting dimmer as far as visibility.So if you want this to be a side marker and a clearance light, you'll need to have two. One on either corner of your trailer.The wiring prongs are sold separately.
You can find those here at etrailer.com. This one from Peterson is going to be part number B431-49. And you can also get a grommet that's a recessed mount, which will look like this. And this part number's going to be 142-18. That just is going to add a little bit of extra shock absorption for our light.
It kind of cleans up the look. We'll still have plenty of room for our wires to come through. But overall just sort of completes the look of our housing.Again, this is sold separately. You can find it here at etrailer.com. Now with the grommet in place, our light will be about three and three quarter inches wide.
But the light on its own will be just two and a half inches in diameter once I get it peeled out of here.So you can see there, two and a half inches in diameter. And then seven eighths of an inch deep. That's going from the inaudible 00:02:48 of the light to the back where those terminals stick out.Again, it is an incandescent bulb. This is going to be all DOT compliant, P2 rated, and it's made in the USA.And that's going to do it for our look at the Peterson trailer clearance marker light.
Average Customer Rating: 5.0 out of 5 stars (7 Customer Reviews)
2-1/2" Round. Waterproof, incandescent trailer light serves as either a side marker light or a clearance light. Built-in reflex reflector. Premium bulb for long life. Recessed mount with grommet (sold separately). Accepts 2-prong plug. P2 rated.GREAT product - FAST shipping!
Fit perfectly. Exact fit.
This light was exactly like the other lights on my horse trailer and matched perfectly. Thank you.
Great product and fast shipping
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.