Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.
Protect your RV slide-out from debris and keep moisture out of your siding with this slide-topper awning. Prevents water damage and mildew. Made for slide-outs that measure up to 10'7" from edge to edge. Includes all necessary components.
Features:
Specs:
To ensure you get the correct size awning for your slide-out, measure from outer edge to outer edge of the trim. You will need 7" of clearance on both sides of the slide-out for the awning. If you don't have 7" clearance on both sides, go down to the next size; this will still give your slide-out plenty of coverage.
If there are two slide-outs next to each other, you will need a total of 14" of clearance between them for them both to have a slide-out awning. Again, you can go down a size if you are low on space.
Without a slide-topper, the roof of your slide-out room is continually exposed and can accumulate leaves and bugs and different types of debris. That debris can build up along the rubber strip at the top of your box, preventing a firm seal when your slide-out is retracted. Rain water can then get in and pool on the top of your slide-out. If you don't clear the water off each time it rains, mold can begin to form. And when your slide-out is pulled in, that mold gets inside your RV.
The Solera RV slide-out awning alleviates those problems by serving as a protective covering over the top of your RV's slide-out. Not only does it prevent debris from collecting on the roof of your slide-out, but it keeps water from pooling and potentially causing damage down the road. Because it mounts directly to the front of the slide box, the slide-out awning is able to automatically extend and retract every time the slide-out room is extended or retracted.
The durable awning fabric holds up to the rigors of the outdoors. It's made of premium 13.5-oz vinyl, which is an upgrade over the 10-oz fabric used in many awnings. This fabric also features heat-welded seams to prevent leaks. And it is made to withstand cold temperatures down to -25 degrees Fahrenheit, so it won't crack or degrade during the winter.
Use the self-tapping screws to secure the included access plate to the side of your slide-out, positioning the plate at the bottom of the T-molding. The two access brackets slide easily onto the access plate's track. The rods that are located at each end of the roller tube, which comes with the awning fabric already mounted, slide through the hole in the two access brackets.
The included awning rail is used to anchor the other side of the fabric to your RV. This rail can be mounted up to 5" above the trim on top of your slide box.
Note: It's important that the slide-topper sits at as steep an angle as possible so that any rainwater will drain immediately. Any water that sits in the awning can stretch out the fabric permanently and warp it out of shape.
California residents: click here
Average Customer Rating: 4.6 out of 5 stars (1107 Customer Reviews)
Protect your RV slide-out from debris and keep moisture out of your siding with this slide-topper awning. Prevents water damage and mildew. Made for slide-outs that measure up to 10'7" from edge to edge. Includes all necessary components.Pretty easy to install, but you definitely need 2 people to mount the rail and the actual awning. 75% of it can be done alone and then just get a helper for the rail and awning. The video that is provided by etrailer was very helpful. Instructions were good. Read them over a couple of times before you start.
Very happy with the topper quality. The etrailer installation videos provided excellent information and were the key to a flawless install. The only issue was the shipping package was damaged with the top shipping tube cap missing. My fear was that the necessary hardware may have been lost. That was not the case and the topper was installed in about 90 minutes.
Jeffrey
5/23/2023
Very happy with the sideout awning one year later.Several of my camping buddies purchased an awning from another popular website and thier awnings have developed slack and water now pools in them. My awning is still nice and tight with no problems. I paid a little more at etrailer.com but definitely got my moneys worth.
I studied the installation instructions prior to the awnings arrival, install went well. Love the slideout awning, keeps rain, dirt and leaves out. Only issue for me was does it come with the trim/mounting or not. You folks said no, I double checked with mfg. and they said no. So I ordered a piece if trim to make sure I could actually install it when it arrived (cost over $100, with expensive freight). Guess what, it came with the trim piece.
Gary
11/5/2018
Installation went fairly easy. The operation and quality is excellent. Had concerns while ordering if the drip rail was encluded with the kit, was told no and so I ordered one frm the mfg. Guess what was the first thing out of the carton,yep the drip rail. Otherwise great !
When I make big purchases for my camper I look everywhere then buy from etrailer. This purchase was no exception. It was delivered to my house in a large corrugated tube and was well packaged. Install took about an hour and a half and was best done with 2 people (If that is not in the product description on the website....it should be even though it may be assumed).
The most nerve wracking part of the installation process was screwing that first screw into the side of my travel trailer. I was fearful that I would see it pop through on the inside. I didn't.
After getting the awning in place and opening the slide I was remarked that it did not look like an aftermarket add-on but looked like it was installed at the factory.
So in the end, the price was perfect, the product shipped well packed, the install went just fine and at the end of last season the cleanest part of my camper was the top part of my slide since it was protected from the elements!
My only complaint would be that the install instructions written by Solera were not the best leaving you to make some decisions based on logical thought and what you have seen on other campers.
Great purchase from a great website.
I did have an issue with, and not sure of the technical term, but the round plastic cord keeping the top attached to the outer roller, was starting to back out of its channel. Luckily I noticed it in time and could shove it back in place and put a small set screw through the bead and channel to keep it in place. Other than that I am completely satisfied with the product. Thanks Mike A.
I ordered three different sizes of slide out awnings and when I called you for correct sizing, you give me the correct size and part number that I needed . The whole process from start to finish was great. I even got follow up calls to make sure everything was going as should be. Very friendly and willing to help answer any questions that I may have.
Will order from etrailer again. Thank you for the good service and the caring of your employees.
This slideout cover was perfect! Easy to install and very sturdy. Much better than the original slideout cover!
Hardest part of the install was cleaning sealer from factory rail not being used. I got help on this one due to weight and length and actual placement of the fabric tube took only a few minutes. Aligned fine and works great.
Easy to install. Did installation by myself! Quality product, quick delivery.
Very nice product. Fairly easy to insta ll.
Quality all around
Carol, I wanted to send you photos of how I received my two packages from the freight company. Y'all have been great to deal with but the delivery method needs improving. As long as my awnings are not missing any parts and are not damaged, I will be happy. But I just got back home and found the boxes like this. I thought you would want to know.
This awning was packaged well and it arrived undamaged, however, when I took it out of the package the top rail was bent and the groove where the awning slides in was damaged. I was able to open the groove by bending and it was still serviceable. The hardware package had been opened previously, but nothing was missing. On the bead end of the vinyl where it is glued together was not glued properly. It was on the leading end of the awning so it would take a beating while driving. I repaired it with super glue and hopefully it will hold properly. Those are my complaints and why I gave it only 3 stars. On the other hand, the instructions were thorough and easy to follow. The hardware installation was straight forward and was completed without issue.
I have purchased from etrailer for years and have been very satisfied with the service and quality of their products. This one didn’t measure up due to the factors above.
Product was destroyed in transit. Please refund my money. I will not be interested in further negotiations with e trailer. It seems to be a systematic issue with your choice of transportation vendor. Best wishes.
Perfect fit for my Coachmen Clipper 17BHS slide out. Install was easy with the etrailer install video! They cover every step in the video and explain assembly better than the supplied instructions. Works great at keeping out the leaves, hoping it works to help keep water out of the slide out seams too.
I purchased a total of 5 slide toppers for my Grand Design Solitude 390RK. After a year of use I love them. No more climbing on the roof to clean off the slide outs before retracting them. Very little flapping and only in very strong winds. Had one person helping to install 3 of them, 2 I installed by myself. It wasn't that hard. Took a little over an hour to install each one. Saved hundreds of dollars by doing it myself. Would definitely buy them and install them again again. Had very fast and good service from etrailer.
I am not sure whose fault it was, but it took about 3 months for my order to be completed. It was backordered initially, which is fine, but somehow shipped two weeks early. I get ready to install and realize the awning rail, and half of the screws are missing. It appeared to be an open box item, or maybe items taken, and sent to another customer. Customer service was great, (through the whole process, keeping me informed) and they requested the missing parts, which were also back ordered. Two months later, the parts become available and they ship me another slide topper, with the awning rail, but missing all of the screws again!!!! This required another order to be placed for the screws, which took almost two weeks to arrive. I then needed to return the extra awning with the freight company, which was aggravating because they kept canceling/rescheduling dates. Finally got it all installed which took about an hour. The slide topper looks great now that it’s finally installed!
Your choice of LTL carrier is poor at best. They arrived a week later than what they originally scheduled. All 3 packing tubes that the slide toppers were shipped in were damaged. Off loading and inspecting was a challenge in 106deg heat and a busy roadway. Did manage to confirm that the hardware kits were still intact. As for tube damage we will see what they look like during install this weekend
The product is a good product if I could get one shipped to me that was not damaged. The shipper etrailer uses Tforce and they really suck. I have received two of these awnings and both were bent and unusable. I received a refund for the first one ordered another it was also bent. I recommend ordering from another vender.
Do you have a question about this RV Awning?
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Frank C.
7/16/2022
It has held up great and still looks good. Works perfectly.