Coupler Pin - 3/8" Diameter x 1-1/2" Long

Video Transcript for Review of JR Products Hitch Pins and Clips - Snapper Pin - 37201251

Jeff: Hello everybody, this is Jeff from etrailer.com. Today we're going to take a look at this three-eighths inch diameter coupler snapper pin. Now this is a spring tension steel snapper pin that'll prevent your trailer's coupler from unlatching and releasing from your hitch ball. This is a spring tension design, creates a nice strong hole. Basically to install this, what you'll do is pull that clip off, open it up like that, and then the three-eighths inch diameter pin will actually slide into a hole that's on your coupler that's usually right for the latch on the coupler. Once that slides all the way through, put your clip over there and then with the spring you just pop it on there and it'll lock it into place and that keeps that latch from popping open and coming off your hitch ball.This is a zinc plated steel, it's corrosion resistant, and the two critical measurements you'll need if this'll fit your coupler is the diameter of the pin, which is the hole size on your coupler, and then the usable length, which is this part right in here.

That would be about the width of the coupler. So you have to choose your coupler lock by the diameter in the usable length. So the diameter on the pin we mentioned is three eighths of an inch and the usable lanes, we'll measure the inside right here, you can see is right at one and a half inches.-But that should do it for the review on the three eighths inch diameter coupler snapper pin.