Square RV LP Gas Regulator Bracket - Qty 1

Video Transcript for Review of JR Products Propane Parts - Square Bracket - 37207-30355

Ellen: Hey everyone. I'm Ellen here at etrailer.com. Today we're taking a look at the JR Products Square RV, Low-pressure Gas Regulator Bracket. This is going to help you mount your regular bracket on a flat surface and also replace the need for having two Z-brackets to come up in a way. So our Z-brackets typically look something like this. So instead of it needing two to mount something on either side, they'll be able to have just the one bracket to do that function for you.It does come with eight screws to get everything installed, and I am going to go over some measurements with you to make sure that this is going to be the right fit for you.

So total width from edge to edge is four inches. Going the other direction, same thing, so that's where we get our square bracket from. The rise here is going to be just about a half-inch, maybe more like 3/8 of an inch, it's kind of hard to see there.And then our tab coming off of either side is about an inch wide in the middle. It's about 1 3/4 inches wide. We'll have our little middle section that's going up and then we'll have another about-inch-wide flange going there.

We'll have our eight holes for our mounting. Each one of those has a 3/16 diameter, which works with our hardware that is included. The distance between our mounting holes, center to center for this middle section, is going to be an inch. Between those two outer holes, it's 3 1/4 inch, center to center. Going the other direction, it's going to be 3 1/2 inches, and that's going to be the same all the way down.It's made of a sturdy steel construction with a gray powder coat finish or kind of a silver.

And if you need any other brackets, you can always check etrailer.com as well as finding any other kind of accessories for your RV. But that's going to do it for our look at the JR Products Square RV low-pressure Gas Regulator Bracket..