Derale Remote Dual Oil Filter Mount Kit w/ 1/2" NPT Side Ports

See what our Experts say about this Derale Accessories and Parts

• Oil Filter Relocation Kit for a 2014 Ford F-150 Lariat 4x4 with 3.5 Liter EcoBoost Motor
  Derale Remote Dual Oil Filter Mount Kit # D15707 is not vehicle specific so you could potentially use it with your 2014 Ford F-150. I assume though that you will want to place the oil filters where you can easily reach them. For that you will need a spin-on adapter to fit in place of your existing oil filter. Your truck uses a filter with 22x1.5 threads. For a spin-on adapter use # D15724. Then you will just need a couple of hose fittings for it, # D98103, and some hose, # D15700 (for...
  view full answer...
• Dimensions of Derale Remote Dual Oil Filter Mount Kit D15707
  I went to our warehouse to pull the Derale Remote Dual Oil Filter Mount Kit # D15707 so that I could take some measurements for you. Please refer to the linked photo I prepared for you. From the mounting surface the overall depth of the mount is 4-3/4-inches. The overall width at the widest point is 7-7/8-inches. Please note that this width dimension does not include any fittings that will be installed nor the room required for the oil lines. Those lines should be routed to avoid any...
  view full answer...
  
• Derale Filter Mount 15707 for Dual Oil Filters and Remote Mounting Location for Easy Access
  The Derale Remote Dual Oil Filter Mount Kit w/ 1/2" NPT Side Ports # D15707 is intended to filter the oil in parallel. The two oil filters will be side by side and you can determine how you want the oil lines run between the two filters. The kit comes with plugs and barb fittings. The idea is to run two filters simultaneously to provide cleaner oil returning to your engine.
  view full answer...
• Will Derale Remote Dual Oil Filter Mount Kit , # D15707, Fit on 1999 Lexus RX300
  On the Derale Remote Dual Oil Filter Mount Kit, # D15707, it allows you to put your filter in a convenient location for easier oil changes. It is a dual oil filter, so it will give you additional filtration and increased oil capacity, it does not allow you to bypass the oil filter. I would also recommend the Derale High-Temperature Replacement Hose for Engine Applications - 25' Long, # D15799,and the Derale Stainless Steel Hose Clamps (4 Piece), # D13008.
  view full answer...
• What are the Different Types of Bypass Situations with Oil Coolers and Filters
  Most vehicles have a oil filter bypasses built into them that will activate when the oil pressure gets too low. This will increase oil pressure but will also run unfiltered oil back through the motor. Oil coolers with bypasses are designed so that the fluid does not run through the coolers until it reaches a certain temperature. This is great for colder climates. BUT what I think you are referring to is a bypass filter which is basically a very intense oil filtration system that allows...
  view full answer...
• Remote Dual Oil Filter Mount Kit # D15707 for a 2003 Jeep Wrangler X with 4.0 Liter
  Derale remote dual oil filter mount # D15707 is not vehicle specific so you would be able to use it on your 2003 Jeep Wrangler X. The filters that you use with this kit would have to have 3/4"-16 threads. If additional hose is needed you can use # D15700 for a 10 foot long section. And for hose clamps use # D13008.
  view full answer...
• Can Derale Remote Dual Oil Filter Mount Kit be Mounted on Vehicle Frame Under Passenger Door
  With enough hose you could mount the remote dual filter kit # D15707 anywhere. You will want to make sure that the filters and hoses so not drop below the frame. Basically anything hanging too low is susceptible to road debris. The safest location would be up under the hood somewhere. Near to the top of the engine compartment would provide ample protection and accessibility. For hose you can use # D15799 which is a 25 foot long piece. We also have hose clamps # D13008 you can use if you...
  view full answer...
• Type of Hose and Hose Clamps for Use with Oil Filter Relocation Kit
  Oil pressure can vary as you can see on the gauge of your dashboard when the engine is running. With our oil filter relocation kits like the part # D15707 that you referenced we recommend high temp hose like the part # D15799 and hose clamps like the part # D13008 and there isn't any issue with the lines or pressures. I would not run this type of hose without hose clamps though as that's most likely going to create a huge mess and potentially damage the engine.
  view full answer...
• Dual Oil Filter Relocation Kit for a 1986 Jeep CJ-7 With a 258 cu in Motor
  The Derale Dual Mount Oil Filter Relocation Kit, # D15749, should work with your 1986 Jeep CJ-7. This kit comes with multiple thread sizes and is designed to work with all of the most popular sizes. From my research it looks like your engine accepts 13/16-16 threads which is compatible with this kit. All of the thread sizes and o-ring diameters are listed on the product page. The filter that fits this kit will have to have 3/4-16 threads. You can use PH8A or equivalent filters with 3/4-16...
  view full answer...

Do you have a question about this Accessories and Part?