2014 Yamaha Grizzly YFM 450 4x4 ATV Winch Mount

Yes, it will. If your 12” UFP brake rotor has 6 on 5-1/2 bolt pattern then the Kodiak 12" Rotor item #KR12S will work.

According to EZ Loader, your trailer uses #LM67048 outer and #25580 inner bearings. The correct bearing kit is the #BK3-310. We have 3 options for disk brake kits for your trailer, with the difference being the finish. The 3 options are as follows:…

Yes. You can use double lip seals in place of single lip seals on your trailer hubs. The double-lip seals are much better at preventing grease leaks and seal blow outs. I have included a link to all of the double lip seals we carry.

It is plastic. The ComeUp UW-5000si Trailer Winch item #CU645010 is a light duty winch so it's housing and base are made of plastic. I attached a picture below that will show you the base. I've also linked an installation video that…

As you've discovered, a 2 inch receiver doesn't always measure exactly two inches by two inches. There is a manufacturing tolerance involved that allows the receiver to be a few hundredths of an inches larger or smaller than 2 inches,…

I went to the warehouse and measured the Bulldog Winch Custom-Fit Steel Winch Mount, part #BDW15151. The mount measures 8-inches tall, 6-1/4 inches wide, and 5 inches deep. The mounting holes on the bottom bracket are 2-3/4 inches center to center.…

The correct custom fit winch mount for a 2014 Polaris 570 Sportsman is the Bulldog Winch Custom-Fit Steel ATV Winch Mount part #BDW15151 which contains the industry standard winch mounting pattern so it will work just fine with the Badlands 3,500…

I reached out to the manufacturer, Bulldog Winch, who was able to supply the installation instructions for the Bulldog Winch Custom-Fit Steel ATV Winch Mount #BDW15116. These instructions will come with the winch mount, and said the 4-bolt pattern…

We have just what you're looking for with the Gen-Y Anti-Rattle Clamp for 2" Hitch Receivers #GY88XR. The sleeve acts as a wedge to take out play between your hitch receiver and extender. Although it does not not require a wrench and…

The Superwinch Terra Series ATV Winch #SW1125220 will fit your 2013 Yamaha Grizzly 550EPS, however, a custom ATV Winch Mount is required. I recommend using the Bulldog Winch Custom-Fit Steel ATV Winch Mount #BDW15132 with is confirmed for your…

We don't have an install video yet for the part #BDW15131, but I did attach a picture that shows the install instructions. It has a diagram that shows how it bolts to the Grizzly frame as well.

The Superwinch Terra Series ATV Winch #SW1135220 is an excellent choice for a winch. I have confirmed with my contact at Bulldog Winch that you should use Bulldog Winch Custom-Fit Steel ATV Winch Mount #BDW15185 to mount this to your 2021 Yamaha…