Redline Tandem Axle Trailer Equalizer Kit Review Video

The MORryde 10" Shock Absorbing Equalizers #MR54AR are currently our only 10" cushioned equalizer. The Road Armor #LC696740 is only available in the 6" length for tandem axle trailers. I recommend using the MORryde Suspension Upgrade…

The picture with the torn up bushing looks like the eye of your slipper spring. Is that correct? If so, it is coming undone and probably the reason you're having this problem. It should be enclosed and not look similar to the hook on the end of…

When installing an equalizer like the Equalizer for 2" Wide Slipper Springs - 11" Long - 7/8" Center Hole #TREQ1304 there is no specific torque setting for the bolts. The correct installation process is to tighten the eye bolts until…

The Center Hanger for TruRyde Equalizer #TRHG291-C is specifically designed to be used with the Equalizer for 2" Wide Slipper Springs #TREQ4541. This is designed to work with trailer axles from 6,000-8,000lbs. The Redline Center Hanger for…

The only difference between the two landing gear sets you referenced is that Landing Gear #RVLG-8HDL comes with a handle and #RVLG-8000 does not. Apart from that they are the exact same landing gear sets, with 20-1/2" of travel, an 8,000 lb…

TruRyde spindles, like #TRU57FR are made of automotive quality high strength steel.

The #99 trailer spindle is typically found on 9,000 lb and 10,000 lb axles. This is not a spindle that we carry at this time, but I did find some of the measurements. I have attached a diagram showing the dimensions of a #99 spindle for you to check…

There are differences in them but we do have what you are looking for and they can in some situations be used together. The Replacement Trailer Hub Bearing you have part #02475 and Replacement Race for 02475 Bearing part #02420 are designed to work…

A goose neck hitch ball, or the center of a 5th wheel hitch head for that matter, will be located either right over the rear axle or an inch or so forward of it. You do not want a goose neck hitch ball to be located behind the rear axle since this…

The center hole for equalizer #TREQ1304 is 7/8 inches in diameter. The closest match we have to a bushing that will reduce that is #TRBU11568 which has a 7/8 inch outer diameter and 9/16 inch inner diameter. But it is 1-3/4 inches long so it will…

The large center hole on equalizer #TREQ1304 should be 7/8 inches in diameter. I checked your order and the equalizer bushings you bought were #TRBU13871. These have a 7/8 inch INNER diameter but the outer diameter is 1-1/8 inches which is why they…

You will want to use a 1" diameter wet center equalizer bolt like #7-136-2-6-112 which inserts in the center hole and bolts to the hanger. I have attached a helpful article about the Slipper Spring Trailer Suspension System. The equalizer…