How Does Bulb of RV Porch Light part # RVPL7CB Get Replaced

Question

Question:

How do I change the bulb?

asked by: Julie F

0

Expert Reply:

The lens of the # RVPL7CB pops out so that you can then replace the bulb with a new 1141 like the LED # DI75VR which will work well and last a long time.

expert reply by: Jameson C

0

Answer 1

The easiest way to cut the oval hole for the Rubber Grommet, #a70gb, in my opinion, would be to use a Light Mounting Bracket for 6-1/2 inch Oval Trailer Lights, BK70BB, as a template and then use a hole saw the correct size to cut a hole on each end…

view full answer...

Answer 2

For a replacement 5th wheel trailer vent that measures 14 x 14-inches you can refer to the linked page that displays all such products that include a 12V powered fan motor. For a variable speed 12V fan assembly with a powered lift feature and remote…

view full answer...

Answer 3

The switch circuit board is accessible for the MaxxAir MaxxFan Mini Roof Vent w/ 12V Fan #MA00-04401M once you're able to pull down the control panel, but since connecting the power wires is part of the installation you might consider just tying…

view full answer...

Answer 4

Ford service bulletin SSM 46257 for the 2017 F-350 indicates that the vehicles equipped with a factory trailer brake controller (TBC) utilize a trailer module (TRM) which initiates the trailer 12V charging system. For trailer charging circuit to…

view full answer...

Answer 5

The difference between the MaxxAir MaxxFan Mini Roof Vent #MA00-04401M and the MaxxFan Roof Vent #MA00A04401K does indeed simply have to do with its profile. The MaxxAir Mini Roof Vent will only extend 2-7/8 inches above the roof when it's closed…

view full answer...

Answer 6

Yes, the fan of the MaxxAir MaxxFan Mini Roof Vent #MA00-04401M can actually operate with the lid closed to move air in the trailer so you can operate it with the lid opened 1-1/2 inches.

view full answer...

Answer 7

If there's an LED bulb replacement that fits your current fixtures yes you can easily convert to LED by just changing them. Do you know what bulbs you have?

view full answer...

Answer 8

I attached a picture that shows the difference between the L1430 and the L1450 connector styles. If you do indeed have a 4-prong connector what you have is the L1430 and not the L1450. Because of that the part #CAM55382 WILL WORK for you as it…

view full answer...