Replacement 10 x 2-1/4 Inch Left and Right Hand Drum Electric Brake Assemblies

Question

Question:

Looking for replacement trailer brakes, I have a tag with 023-216-00 on a drivers side. Need replacement numbers for both left and right please. Thanks

asked by: Doug

0

Expert Reply:

I would be happy to help you. The 023-216-00 number you found is for a 10" x 2-1/4" left hand drum brake assembly. To replace it you will need the Left Hand: Dexter Electric Trailer Brake Assembly - 10" - 3,500 lbs item # 23-26 and Right Hand: Dexter Electric Trailer Brake Assembly - 10" - 3,500 lbs item # 23-27. The complete kit is the Dexter Electric Trailer Brake Kit - 10" - Left and Right Hand Assemblies - 3,500 lbs item # 23-26-27.

expert reply by: Jerred H

0

Answer 1

If by serial number you mean VIN and the trailer manufacturer is still in business then yes, you would likely be able to obtain the bearing numbers from the manufacturer. If none of the above are true, then the only other way to determine which…

view full answer...

Answer 2

I checked out our Expert answers and could not find a reference to limits on the wheel lugs the #RA-16HST would work with. As long as the pilot hole on your tire measures at least 2-15/16 inches diameter, your tire will fit over the end of the arm…

view full answer...

Answer 3

Hey Jeremy, Typically with boat trailers the manufacturer will install hydraulic surge brakes because you don't have to worry about the water damaging wires like you would with electric brakes. That being said, if you use a heat shrink butt…

view full answer...

Answer 4

Traditionally, trailer manufacturers did not use electric brakes on boat trailers because the brake magnet wiring and trailer wiring did not always have the best insulation or water protection. These days, more and more manufacturers are using…

view full answer...

Answer 5

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

view full answer...

Answer 6

Based on what information I could find about AL-KO 8490 hub and drums, it is rated for 3,500 pound axles, has a 5 on 4-1/2 bolt pattern, and is a 10 by 2-1/4 inch drum. If this is the case, we have several options for you. I have attached a link to…

view full answer...

Answer 7

Hey Sam, so from previous customers we have determined that the Sure Trac axles use the standard trailer axle components so yes the brake assemblies part #AKEBRK-35-SA and the hub part #AKHD-545-35-K would fit and work great.

view full answer...

Answer 8

Yes, the Electric Trailer Brake Kit - Self-Adjusting #AKEBRK-35-SA that you referenced are an exact replacement for the AxleTek assemblies you have now that have Axletek-10-GG stamped on them. If you check out the attached picture you can see the…

view full answer...

Answer 9

Hey Roy, The only U-bolt kit we currently only offer for 1-1/2" square axles is part #CE23102, which only has a 3-3/8" length so it likely wouldn't be the best option for you. Instead you'll want to order the 1-1/2" Square…

view full answer...

Replacement 10 x 2-1/4 Inch Left and Right Hand Drum Electric Brake Assemblies

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching