Curt QuickPin No-Latch Trailer Coupler Review C22CR Video

Based on the dimensions of your bearings that you listed you have an 84 spindle and we have a hub that will fit it easily. The part #84545BX is a confirmed fit for your spindle and would work well. It has the same 5 on 4-1/2 inch bolt pattern too.

I did some research online and I found a coupler with some lower mounting holes that looks similar to the Ram's. It is the Titan Coupler - Painted - Multi-Fit Ball - 3" Channel - Bolt On - 5,000 lbs item #T2343400. I have attached a…

The Dual Hitch Receivers such as part #RM-077-2 cannot be used for towing a trailer. These receivers are meant for use with a towbar carrying a rolling load and an accessory such as a bike rack or cargo carrier. We offer a Curt Ball Mount with 2 inch…

I attached a picture that shows what type of lighting requirements are needed for a trailer over 80 inches in width as well as a link down below that covers this as well.

The tires will have some air in them, but you will need to check the air pressure once you mount the tire to your trailer and adjust it to the proper psi to ensure the maximum performance of the tire. The recommended psi will be located on the…

From inside to inside the mounting bracket should be spaced at 29-11/16 inches to mount the CE Smith Single Axle Trailer Fender part #CE19504-2.

The CE Smith Single Axle Trailer Fenders w/ Top and Side Steps - Black Plastic - 14" Wheels - Qty 2 #CE19504-2 and single fender #CE19504 will attach to your trailer's existing brackets. If your trailer doesn't have the brackets then you…

I went out to our warehouse to take a look at both the CE Smith Single Axle Trailer Fenders - 12" Grey #CE19502-2 and the larger 13" Black #CE19503-2. Both options represent the only color available from CE Smith in the respective sizes.…

There are a number of 40 inch fenders available for your Boston Whaler Nantucket Trailer, each of which is designed for single axle trailers with 13" diameter wheels. The CE Smith Single Axle Trailer Fender w/ Top and Side Steps #CE19503 is a…

We carry exactly what you are looking for, the BoatBuckle Pro Series Kwik-Lok Bow Tie-Down Strap #IMF18741. The hook end of this strap attaches to your boat's bow while the loop on the other end goes around your boat trailer's frame. This is…

The outer tube width/height for the Buyers Products Black Receiver Tube #337RT25824B is approximately 2-1/2 inches. It can vary slightly from one to the next due to the powder coating process.

The best solution to lift a tandem axle trailer like yours 2 inches is the 2 inch lift for tandem axles from Lift Kit #RR23QX. This attaches to the suspension hangers and gives you a safe and very stable 2 inch lift like you are needing!