Customers compare CAM59213 to these similar products
Products Featured in this Video
Rate your transcript OrderClientKevin BrossRef #20648Order #TC1003303131 Connect your one-pound disposable cylinder to an appliance designed to use a twenty-pound propane tank. Camco's Propane Adapter connects both ACME and POL connections. .… see more >
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Videos
Help Articles
Expert Answers
The Camco Olympian Wave 3 Catalytic Safety Heater for Small RVs #CAM57331 can be used with 1 lb disposable tanks when you use the Camco Low-Pressure LP Gas Regulator w/ 6' Long Hose #CAM57703 and adapter #204132-MBS or #CAM59213. You may also be…
view full answer...The Camco Quick-Connect Kit for Low Pressure Propane Systems #CAM59853 will replace a quick disconnect for a propane tank as long as it is a low pressure system like this kit is designed to work with. So no other parts would be needed. This system…
view full answer...Instead of a regulator with a 6 foot hose we have the part #CAM59863 which comes with a 22 inch long hose instead that you could use with the Camco heater #CAM57331. To then adapt the hose you'll need the adapter #CAM59213.
view full answer...The Solera RV Slide-Out Awning #LCV000251461 that you were already looking at is the correct size for your 115" flange to flange measurement. You would not want to go a size larger as the extension rods that hold the roller tube to the slide-out…
view full answer...Yes, the MORryde Camping Kitchen with Storage Compartment for Jeep Wrangler JLU - No Drill #MR45HR will be a great addition to your 2022 Jeep Wrangler 4xe. MORryde advertises this as designed for the 2019 model year but that it can fit pretty much…
view full answer...Yes. The Camco Olympian Wave Heater #CAM57331 can be used as your primary source of heat and can be setup to be both permanently installed or portable. This is a heating solution that is safe to sleep with the unit on, but you will need to leave a…
view full answer...I reached out to my contact at Camco regarding the Olympian Wave 3 Catalytic Safety Heater #CAM57331 and he said the heater requires at least 4" of clearance on each side and at least 30" of clearance from the front of the unit (where the…
view full answer...In regards to the Camco Olympian Wave 3 Catalytic Safety Heaters like part #CAM57331, Camco states that the space in which the heater is used must have sufficient airflow to allow for a complete burn of the gasses. In the owner's manual for the…
view full answer...What you need is the Camco Propane Adapter #CAM59213. This allows you to adapter a hose like part #CAM57703 that you'd use for the Wave 6 #CAM57341 to connect to a 1-lb (throwaway) bottle of propane. Attached is a quick demonstration video that…
view full answer...You will want to make sure that you have proper support behind the fiberglass location you plan on mounting this rail too. I was able to go out to the warehouse and find that on the product Camco recommends this product be installed by a qualified RV…
view full answer...If you're searching for a hose to go from the tank to the regulator then you'll need the MB Sturgis Propane Pigtail part #100575-36-MBS for 3' long or part #100575-48-MBS for 4' long. Please note, the pigtail hoses use an inverted…
view full answer...The Phoenix USA Wheel Center Cap part #PXQ2010 has right hand threads (threads run clockwise) but that does not mean there is a left and right hand cap. You will need to check the bracket of your existing cap to see if there is a L at the end of…
view full answer...