Yakima Hitch Bike Racks Review - 2013 Dodge Ram Pickup Video

If you have a DoubleDown Ace then you would need adapter #Y8890342 and not #Y8890174 which is for the original DoubleDown (the Ace models came later). That is the issue, just need to use the proper adapter for Ace models, #Y8890342.

The correct replacement shank adapter for the Yakima TwoTimer 2 Bike Platform Rack is the Replacement Yakima Two Timer 2 Inch Adapter part #8880519.

To find out if the Yakima Replacement Adapter Sleeve #Y8890342 is the correct part for your hitch bike rack you'll first want to try to confirm that the rack is either one of the HighLite or DoubleDown Ace racks. The hole in the…

The Replacement 2" Hitch Adapter Sleeve for Yakima TwoTimer Bike Rack #8880519 is only compatible with the TwoTimer. Yakima did make a replacement 2" adapter for the DoubleDown, but it has been discontinued. Although this will not work for…

I can certainly help you out. The hardware used on the Thule Adventurer is #TH04997 that you have referenced. There is a specific order in which all of the parts will go on the crossbars. I have included a picture that shows how all of the parts go…

Both of the 2 inch hitches we offer for your 2018 Mazda CX-9 will have their hitch opening below the rear bumper of the vehicle. The better option is the Draw Tite part #76020 over the Curt part #C13284 as the Draw Tite has a better price, slightly…

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

If the trailer wheels scrubbed (dragged and scrapped the ground instead of rolling) when jack knifed then it could have thrown something out of alignment or damaged something. First, inspect the suspension. Look for any elongated holes where…