Trailer Wiring Harness Installation - 2017 Hyundai Santa Fe 118269 Video

First you would need a 4-way for your 2017 Hyundai Santa Fe to start for trailer wiring. For that you would need the part #C56332. Now if your trailer does not have brakes all you would need is the part #37185 as an adapter to convert the 4-way to a…

Let's start with the trailer hitch receiver, and I checked with the manufacturer for you and can confirm that the Curt Trailer Hitch Receiver #C13153 is a fit for a 2017 Hyundai Santa Fe Limited, including your Limited Ultimate model. In regards…

The wiring harness confirmed to fit your 2017 Hyundai Santa Fe Limited is #C56184. I've linked a video of the install on a 2014 Tucson which is a similar process to your Santa Fe. The Curt #C13153 is the trailer hitch I suggest for you. This…

I haven't heard of the Curt 7-way tester not working with OEM brake controllers. There was a Tekonsha tester that had problems with Dodge and GM trucks so it is possible. We have been able to confirm that the Pollak 7-Way to RV Socket LED Circuit…

The Brake Controller Install Kit part #ETBC7 that you referenced would be easily installable by a local mechanic to you. It's a pretty basic wiring job that wouldn't be too hard at all. I attached an install video that shows the kit being…

When we installed the Curt Class III Trailer Hitch Receiver #C13152 that you referenced on a 2016 Hyundai Santa Fe Sport, we found the inside top of the receiver to the ground measured 13 inches. I've attached a photo showing this measurement for…

I have attached a link to all of the trailer hitch options we offer for the 2017 Hyundai Santa Fe Sport. The hitch I recommend for your Santa Fe Sport is the Curt Class III Round Tube Receiver Hitch #C13152 because it will offer you a 2 inch hitch…

The 18 guage blue wire on the Tekonsha OEM Replacement Vehicle Wiring Harness w Brake Controller Adapter Item #TK22113 is for trailer brakes. Blue = Trailer Brakes Yellow = Reverse light circuit Green = Taillights Brown = Right Turn and Stop Red =…

According to the install instructions for the Tekonsha 7-way part #TK22113 that fits your 2018 Dodge Durango the blue wire gets routed through the grommet in the floor on the driver side into the rear cargo area and then routed behind side cargo trim…

The flicker you are seeing on the brake output circuit of your vehicle is normal. Brake controllers will lightly pulse their output circuit to check to see if a trailer is connected due to the amperage draw of the brake magnets. So what this all…

The Tekonsha OEM Replacement Vehicle Wiring Harness #TK22113 comes with everything you need to install the harness, so there's not any additional inline fuses or anything needed. The blue wire that connects to the rear lights is an 18 gauge wire,…

The 12 gauge blue wire is the brake controller output. If you have a brake controller installed then you will be able to test the wire for signal when the brake controller is sending power to the trailer. I was able to find a picture that a customer…