Trailer Wiring Harness Installation - 2015 Ford Explorer 118540 Video

The typical tire should run about 158 degrees (Farenheidt) once you get going down the road, but this can vary greatly depending on the weight of the trailer, how fast you're traveling, and also driving habits. So while 158 is probably…

There is a wiring harness available for your 2015 Ford Explorer but the Draw-Tite Trailer Hitch #76034 that fits your Explorer does not come with a wiring harness included; it would need to be purchased separately. The wiring harness I recommend…

Using a 60/40 ratio is a great place to start when deciding where to place your axle, placing 60 percent of the weight in front of the axle. However, there are a couple other factors that come into play. I have attached a photo that outlines that…

If you are only having problems with one light, you can check to see if you have a ground problem on your trailer that is hooked up to your 2013 Ford Explorer. You want to make sure that the ground wire (usually white) on the trailer connector is…

The best way to determine if your Explorer is equipped with the tow package is to check with your Ford dealer. They should be able to run the VIN and be able to tell you exactly how the vehicle was equipped. I'm assuming you're needing the…

With the installation of a trailer hitch on your 2016 Ford Explorer like the part #76034 that you referenced you will still be able to use the hands free liftgate option, but you will need to kick your foot to the sides of the trailer hitch between…

If your 2015 Ford Explorer has a factory 7-way all you would need is the part #3035-P to install a brake controller like the part #90195. If you do not have any trailer wiring you would need to first install a 4-way like the part #118540. Now…

To connect your vehicle that has a 4-Way flat connector to your trailer that has a 7-Way connector, you will need to install a 7-Way on the rear of your vehicle. If you just want or need the tail light functions to operate on your trailer you will…

You can use the Tow Ready #118540 with no problems, as long as your Explorer is equipped with the connector shown in the photo I provided. The signals used at this connection point are already converted, so no additional converter is needed. This…

You will still be able to use the trailer with the 4-Way after installing the 4 to 5-Way adapter, #20036. First, you could just remove the adapter if you wanted to and then plug in the 4-Way like normal while stowing the adapter in the truck. The…

I have attached a link to an installation video that shows the Curt T-Connector Vehicle Wiring Harness, part #C56172 being installed on a 2015 Explorer. Since the 2015 and 2016 are within the same generation, the installation would be the same. The…

A link to the trailer wiring you are asking about is provided, just scroll down the page to select the connector you have on your vehicle and trailer. The wires on the 5 pole flat are as follows White/ground, Brown/taillights, Yellow/left turn and…