Trailer Hitch Installation - 2014 Jeep Grand Cherokee - Draw-Tite Video

The Kuat Sherpa 2.0 #SH22G and the NV 2.0 #NV22G that you referenced are both excellent platform-style racks that will hold your bikes by the front wheels with no frame contact. These are top-of-the-line carriers and you really would not go wrong…

Based on what you described you might be best served with a keel roller assembly like the #CE10455G which is 12 inches long and has a pretty low angle to the roller which sounds like would be a great match for the contour of the bottom of your boat.

A vehicle's towing capacity depends on the entire complement of factory equipment installed on it. The best place to confirm this is the owner's manual. I checked an online edition of the manual for the 2014 Jeep Grand Cherokee Limited with…

If you click on the link to the installation instructions, at the bottom of the instruction sheet, right under the step-by-step run through of the install steps, you'll see the torque specs. We don't publish them because the hitch…

If it was my vehicle I would go with the factory tow package 7-way and 4-way wiring kit part #C55774 that you referenced since you have the connector present for it already. There's a good chance the wiring is already active too but at worst a…

To install a 7-way on your 2016 Jeep Grand Cherokee Altitude you'd need to first start with a 4-way like the #C62VR which is a confirmed fit so that you could then convert to a 7-way with the #37185. Now if the trailer you plan to tow has brakes…

The Draw Tite hitch part #DT38MR is a confirmed fit for your 2014 Jeep Grand Cherokee Laredo and would still fit whether you had the removable rear fascia or not. At worst you'd just have to trim the rear fascia of your vehicle so that your hitch…

You have a few really great options, the first is the Draw-Tite Max-Frame Trailer Hitch Receiver, #75699. This is a custom fit, class III - 2" hitch with maximum gross trailer weight of 5,000 lbs. 7,500 lbs. when used with a weight distribution…

Yes, for your 2018 Jeep Grand Cherokee, you will need to remove the bumper/fascia in order to install the Draw-Tite hitch that fits: - Draw-Tite Max-Frame Trailer Hitch Receiver #DT38MR The reason why is because this hitch is totally concealed behind…

I recommend Curt T-Connector Wiring Harness part #C55774 for the 2012 Jeep Grand Cherokee with factory tow package. I recommend the Curt Wiring because it gives you a 7-way plug and a 4-pole flat so you can tow a trailer with either connector. It…

If your 2015 Grand Cherokee has the factory tow package, you will have a connector at the rear of your vehicle behind the bumper. The harness I recommend is the Curt T-Connector Vehicle Wiring Harness, part #C55774. This just plugs into the round…

Sometimes after installing some aftermarket wiring the Jeep "tow package" wiring circuit will need to be activated. This can only be done at a Jeep dealer and it sounds like this is what is going on. You can verify this by checking to see…