Trailer Hitch Installation - 2014 Dodge Ram 2500 - Curt C15409 Video

There is a weight distribution hitch option for your new 2021 Intech Flyer Discover with a completely covered A-frame. Instead of using a standard weight distribution hitch which has brackets that go around the frame you will need to use a weight…

The OEM hitch on your Ram truck is welded to a cross member located behind the rear bumper. The cross member is an integral part of the vehicle structure and should not be removed, according to Curt. I attached an install video for this hitch part…

The integrated cable locks that come on the Kuat NV 2.0 Base #BA22B automatically lock when you connect the 2 ends together. When you put the key in and turn it you are actually unlocking it which is why they pop out. If you skip to the 4:15 mark on…

The Draw-Tite Ultra Frame Trailer Hitch Receiver - Custom Fit - Class IV - 2" #41929 is a custom fit for your 2004 Ram 3500. It will hang below the frame about 12 inches and will be about 7 inches from the back frame rail. If you have the…

I do recommend you use a weight distribution system on the Intech Explore Travel Trailer while towing with your 2018 Toyota Highlander. The reason for this is because the weight of the trailer will be over half the weight of the vehicle which is the…

Not all aluminum trailer frames are strong enough for use with a steel weight distribution (WD) system. It is possible that the stronger steel WD components could put too much stress on the frame. If your trailer has an aluminum frame you'll…

This is a pretty common issue with aluminum frames so we definitely have a options available for you. With that being said, the 8 inch frame height will make things a bit more difficult, but not impossible. First, the Curt TruTrack Weight…

You should not have any issues using weight distribution with your aluminum trailer, but you will want to check with the trailer manufacturer to be certain. My contact at Reese has stated that as long as the trailer manufacturer says it's ok then…

When it comes to installing The CargoSmart Anti-Rattle D-Ring Tie-Down Anchor - Bolt On - 1/2 inch x 3-1/4 inch - 3,666 pounds #3486509 into your aluminum trailer you can. Aluminum is a soft metal and therefore a standard HSS drill bit will be able…

The Curt Trailer Hitch #C15409 will fit your 2019 Ram 2500 and you will not need to remove your factory hitch; this will fit underneath it. I added a cut out of the linked installation instructions which show that this hitch will fit under the OEM…

Yes, but only the rear set of TorkLift Custom Frame-Mounted Camper Tie-Downs will need to be replaced when upgrading to the TorkLift SuperHitch Magnum Trailer Hitch Receiver part #TLD1102-30 from the factory trailer hitch on your 2011 Ram 3500. The…

You will definitely be able to install the Curt Trailer Hitch Receiver - Class V XD - 2" #C15409 on your 2006 Dodge Ram 2500 yourself without the need for a professional. The reason for that is because no drilling is required to install the…