Trailer Hitch Installation - 2008 Subaru Outback Wagon - Draw-Tite Video

According to Thule and Yakima, the 2008 Subaru Outback Wagon is not suitable for use with a trunk mounted bike rack because the rear hatch is not strong enough to carry the weight of the carrier and the bikes. This leaves a roof or hitch mounted…

The plug is behind the driver side taillight. You will need to remove several interior panels to access it. To see where the plug is for installing the Curt Wiring Harness part #C55370 check out the video I attached. It's for the Tow Ready…

For your 2008 Subaru Outback Wagon LL Bean with dual exhaust, I recommend the Draw-Tite Class III Max Frame Receiver Hitch #75560. This is confirmed to fit your vehicle and we have also had customers install this hitch onto their LL Bean Model with…

The Draw-Tite 2-Inch Class III Max Frame Hitch #75560 is a confirmed fit for your 2008 Subaru Outback Wagon as long as you do not have the Sport Edition. One of our local customers purchased this hitch for their 2008 Outback and the linked video…

It appears you are connecting your tow vehicle wiring to a 6-way connection like the RoadMaster 6-Wire Flexo-Coil Kit #RM-146. Making these connections is not difficult and I've attached a video and photo as well as linked an article to…

Yes, the Curt Echo brake controller part #C51180 that you referenced is compatible with electric over hydraulic actuators like your Dexter.

The differences between the Yakima HoldUp #Y02443-2 and the HoldUp EVO #Y02479-2 include an integrated SpeedKnob to take out movement of the bike rack, an easier system for tilting the bike rack, and the ability to add fat bike tires (up to…

The Torque Specification is found in the installation instructions on our product page on the etrailer #e98846 receiver hitch. A Torque Wrench #PT87ZR would be the type that you would need to achieve that rating.

When we installed the Draw-Tite Hitch part #75560 on a 2008 Subaru Outback like yours we found that the top of the hitch measured 13-1/2 inches from the ground. In most circumstances this wouldn't be an issue. We have a ton of reviews for…

When the Draw Tite hitch part #75560 is installed on your 2008 Subaru Outback the hitch height measured from the top of the hitch opening to the ground is 13-1/2 inches.

Thank you for the purchase of the Draw-Tite Max-Frame Trailer Hitch Receiver #75560 for your 2009 Subaru Outback. I have added a link below to the installation instructions in English, and added a cut out for you showing the torque specs. I have…

When we installed the Draw-Tite part #75673 on a 2016 Subaru Outback Wagon like yours we found that it measure 5-1/2 inches from the center of it's hitch pin hole to the outer most portion of the bumper. The difference between this and the…