Timbren Active Off-Road Bumpstops Installation - 2013 Toyota Tacoma Video

Yes, the Timbren Rear Suspension Enhancement System #TGMRCK35S can still be used on your 2007 Chevy Silverado even though its been lifted. You'll just need to install a spacer to get the gap between the Timbren and the axle around 1"…

For your 2018 Toyota Tundra the suspension enhancement I recommend is the Timbren kit part #TABSOSR because this kit installs easily, gives you the suspension support you need to greatly reduce the sag, and because it doesn't require…

Unfortunately Timbren does not make their Timbren Active Off-Road Bumpstops #TABSOSR kit without the axle bracket, so if you don't need it you'll just ignore it and install everything else. To figure out if you need a spacer kit…

The Timbren Front Suspension Enhancement System like part #TFXF1004A should be in constant contact with the front end. If you have a gap from your leveling kit then you will want to use the Timbren 1/2" Spacer for Raised Frame Vehicles…

You have an interesting combination of circumstances with your 2008 Nissan Titan 4x4 that is both towing a 7000-lb trailer with a weight distribution hitch (WDH) and also using a fairly heavy Iron Bull front bumper with winch/hitch to maneuver the…

The Timbren Trailer Suspension Enhancement System for Underslung Axles #T92MR is 5-1/4" tall. Timbren recommends The spring be in constant contact with the frame at all times. So ideally you will want exactly 5-1/4" from your axle tube to…

The Timbren Active Off-Road Bumpstops - Rear Suspension - 3,600 lbs #TABSTRFK have bump stops and mounts that are 5-1/2 inches tall overall and u-bolts that are 8-1/4 inches long and 3-3/4 inches on center. I've attached a photo to assist. These…

When installing any Timbren system on the 2019 Toyota Tacoma you should have about 1/2" to 1-1/2" between the frame and the spring after installation. You won't necessarily be losing wheel travel when you use a Timbren Rear Suspension…

I do have an option for you but we do not currently offer a Dexter straight axle with the spring center and hub face dimensions that you provided. However, we do have the Timbren Axle-Less Trailer Suspension System part #TASR5200S03 which will…

To select the correct B&W Continuum Weight Distribution System for your needs you will first need to determine if you have a standard coupler(mounts on top of trailer frame rails) or an underslung coupler(mounts on the bottom of the trailer frame…

It looks like the previous owner of the trailer had vehicle tires installed since there are very few trailer tire manufacturers that carry a 235/75R15 size. Even though it might work for a while, trailer tires are always better to use for trailer…

The jounce spring of the SumoSprings Solo Custom Helper Springs #SSR-610-40 measures 4 inches tall; they are also 3 inches in diameter. These springs are a direct fit for your 2012 Nissan Frontier. I have added a link to a video review for you to…