Timbren Active Off-Road Bumpstops Review Video

For your 2018 Toyota Tundra the suspension enhancement I recommend is the Timbren kit part #TABSOSR because this kit installs easily, gives you the suspension support you need to greatly reduce the sag, and because it doesn't require…

The Timbren Active Off-Road Bumpstops - Rear Suspension - 3,600 lbs #TABSTRFK have bump stops and mounts that are 5-1/2 inches tall overall and u-bolts that are 8-1/4 inches long and 3-3/4 inches on center. I've attached a photo to assist.…

Yes, the Timbren Rear Suspension Enhancement System #TGMRCK35S can still be used on your 2007 Chevy Silverado even though its been lifted. You'll just need to install a spacer to get the gap between the Timbren and the axle around 1"…

For your 2015 Toyota Tacoma we offer the SumoSprings like part #SSR-610-40 which are very similar to the Timbren systems that you referenced.

The SumoSprings Rebel Custom Helper Springs are only rated to -25 degrees Fahrenheit so if you'll be using the truck in temperatures below this then you may have to consider other options like the Timbren Rear Suspension Enhancement System.…

According to my contact in the Engineering department at SuperSprings the correct SumoSpring fit for a 2015 Suburban 1500 would be #SSR-204-40. According to them, the SumoSprings #SSR-204-40 springs will remain functional down to -25º F.…

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the…

When installing any Timbren system on the 2019 Toyota Tacoma you should have about 1/2" to 1-1/2" between the frame and the spring after installation. You won't necessarily be losing wheel travel when you use a Timbren Rear…

The Timbren Trailer Suspension Enhancement System for Underslung Axles #T92MR is 5-1/4" tall. Timbren recommends The spring be in constant contact with the frame at all times. So ideally you will want exactly 5-1/4" from your axle…

There is a weight distribution hitch for 500 lbs to 600 lbs of tongue weight you can use for your boat trailer's pole tongue, but the tongue will require an adapter to work. What you will need is the following: - Fastway e2 Weight Distribution…

For your 2015 Nissan Frontier I would recommend the SumoSprings Solo Custom Helper Springs #SSR-610-40, which are the blue SumoSprings. Although SumoSprings are pretty good about not affecting your unloaded ride quality you're right, the others…

The Timbren Front Suspension Enhancement System like part #TFXF1004A should be in constant contact with the front end. If you have a gap from your leveling kit then you will want to use the Timbren 1/2" Spacer for Raised Frame Vehicles part…