Timbren Vehicle Suspension - Rear Axle Suspension Enhancement - TABSOSR Review Video

Yes, the Timbren Rear Suspension Enhancement System #TGMRCK35S can still be used on your 2007 Chevy Silverado even though its been lifted. You'll just need to install a spacer to get the gap between the Timbren and the axle around 1" to…

For your 2018 Toyota Tundra the suspension enhancement I recommend is the Timbren kit part #TABSOSR because this kit installs easily, gives you the suspension support you need to greatly reduce the sag, and because it doesn't require monitoring…

The Timbren Front Suspension Enhancement System like part #TFXF1004A should be in constant contact with the front end. If you have a gap from your leveling kit then you will want to use the Timbren 1/2" Spacer for Raised Frame Vehicles part…

You have an interesting combination of circumstances with your 2008 Nissan Titan 4x4 that is both towing a 7000-lb trailer with a weight distribution hitch (WDH) and also using a fairly heavy Iron Bull front bumper with winch/hitch to maneuver the…

When installing any Timbren system on the 2019 Toyota Tacoma you should have about 1/2" to 1-1/2" between the frame and the spring after installation. You won't necessarily be losing wheel travel when you use a Timbren Rear Suspension…

The Timbren Active Off-Road Bumpstops - Rear Suspension - 3,600 lbs #TABSTRFK have bump stops and mounts that are 5-1/2 inches tall overall and u-bolts that are 8-1/4 inches long and 3-3/4 inches on center. I've attached a photo to assist. These…

From what I could find, it looks like the plug for a trailer brake controller on your 2023 Nissan Frontier is located in the same location as the 2022 model year. That is behind the side panel by the OBD connector and is likely pushed back into the…

We do have the Timbren Rear Suspension Enhancement System #TTORTUN4 for your 2005 Toyota Tacoma Pre-Runner 2wd. This kit has a rated capacity of 6,000lbs to reduce sag and improve stability. We also have the Timbren Active Off-Road Bumpstops #TABSOSR…

According to my technical contact at Curt Manufacturing their Class V Hitch #C15302 will fit your truck, if it were equipped with a standard 265mm wide spare, with about an inch of extra space. The hitch was engineering with this tire size in mind.…

Curt does not have that measurement available, but you can determine this for yourself by taking some measurements from the underside of your truck. Using the diagram I edited for you, locate the weldnut that would serve as the rear-most attachment…

With Curt Trailer Hitch Receiver #C15302 installed on a 2003 Chevy Silverado 2500 short bed the hitch will be in the same position as a factory hitch or at least within a fraction of an inch. By that I mean the receiver will be right under the rear…

If you check out the picture I attached you can see that the hitch opening for the Curt #C15302 that you referenced tucks right up under the rear bumpers so it would give you the exact same ground clearance as your current hitch. Which means your…