Roadmaster EZ5 Base Plate Kit Installation - 2018 Ford F-150 Video

According to the owner's manual for a 2018 Ford F-150 you will need to do the following for a 4WD to get it in the Neutral position for flat towing: 1 - Put the ignition in the on position, but do not start the engine. If your vehicle has…

Yes the Roadmaster base plate kit part #RM-524431-4 is a fit for your 2018 Ford F-150 and would work great with the Roadmaster Falcon tow bar part #RM-520.

It is highly unlikely that we will have a flat towing solution for your bus. Our tow bar inventory is geared more towards small automobile to medium-sized truck flat towing. The Roadmaster BlackHawk 2 All Terrain Tow Bar, Item #RM-422, is one of…

Yes you are correct. Since you want to wire up your vehicle with the #RM-15267 like a combined taillight circuit you'd run the circuits of the install harness to the stop/taillight circuits. Even those lights normally don't carry the…

We have exactly what you are looking for. It is the Roadmaster Diode 7-Wire to 6-Wire Flexo-Coil Wiring Kit #RM-15267. This extension has a 7-way plug to a 6-way plug along with the 6-way connector and the 4 diode s with wiring. This is a very user…

For lighting you can use the diode kit, #RM-15267, and not have to worry about cutting into the taillight housing. This will splice into your taillight wiring to allow your tow vehicle to control the taillight assemblies of the towed vehicle. This…

There are a few troubleshooting steps to help you figure out why you have no power. I would start by making sure that there is not any corrosion or debris blocking your connection points. If they are clean or still no power after cleaning, I would…

Since you are not getting the 12V power when your truck is running, you most likely don't have a fuse issue as you stated their isn't a specified fuse or relay in the owners manual. The issue is that your truck is computerized even at the…

I do have an option for you but as you mentioned, the 2016 Ford Edge EcoSport with the 2.0L I4 engine can't be flat-towed with four wheels down. This has to do with the automatic (6F35) transmission that is mated to the engine rather than the…

In order to flat-tow a thirteenth generation (2015-2018) Ford F-150 with all four wheels on the ground behind a motorhome you are going to need a tow bar, base plate kit, safety cables, tail light wiring harness, supplemental braking system, and…

You will not need additional diodes when installing the Demco SBS Stay-IN-Play DUO Supplemental Braking System #SM99251. The 10 amp diode that come with the kit are only needed if your tow wiring harness is not diode-protected. Since yours is not,…

You can connect the Replacement LED Monitor Light #SM99612 to the blue wire of the breakaway switch that comes with the SMI Stay-IN-Play DUO #SM99251 but since you don't have to disconnect the battery on your 2004 Jeep Liberty you can just route…