Diode Tow Bar Wiring For Vehicle with Separate Circuits
Question:
I have the Roadmaster 15267 Toad Wiring Kit W/6-7 FLEXCORD. My circuit is separate, brake and turn signal. I want to wire it combined so it works with my class c rv. From the instructions it looks like the diodes only go on the brake/taillight circuit and I dont touch the turn signal circuit. Is that correct? Thanks
asked by: Thomas
Helpful Expert Reply:
Yes you are correct. Since you want to wire up your vehicle with the # RM-15267 like a combined taillight circuit you'd run the circuits of the install harness to the stop/taillight circuits. Even those lights normally don't carry the blinker circuits they will illuminate as if they did wit the # RM-15267 installed.
I attached a diagram that shows how it will wire up.
Product Page this Question was Asked From
Roadmaster Diode 7-Wire to 6-Wire Flexo-Coil Wiring Kit
- Tow Bar Wiring
- Splices into Vehicle Wiring
- Diode Kit
- Universal
- Tail Light Mount
- Roadmaster
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Roadmaster Single Park Light Diode
- Q&A: How to Prevent Trailer Battery From Backfeeding to Vehicle Battery
- Q&A: Roadmaster Diode 7-Wire to 6-Wire # RM-15267 Wiring Diagram for Motorhome to 2016 Ford Focus
- Article: Must-Have Flat Towing Components
- Article: Roadmaster Vehicle Specific Base Plates
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Wiring Diagrams
- Article: Flat Towing Package for 2018 Jeep Wrangler JL and JL Unlimited
- Q&A: Recommended Flat Towing Set Up for a 2019 Chevy Colorado
- Article: Tow Bar Wiring: Which Wiring Kit is for You?
- Article: How to Choose a High-Low Adapter
- Q&A: Choosing Between the Brake Buddy Select 3 and the Blue Ox Patriot Supplemental Braking System
- Q&A: Recommended Flat Towing Parts for a 2024 GMC Canyon Denali
- Q&A: Which is Better Roadmaster or Blue Ox Tow Bar
- Q&A: Is The Curt C96JR Tail Light Kit Compatible With A Brake Buddy Brake System?