Redarc Tow-Pro Elite Trailer Brake Controller Installation - 2018 Jeep JK Wrangler Unlimited Video

The only difference between the 2nd and 3rd versions of the Redarc Tow Pro Elite is size of the control knob, with no functional changes being made. The Redarc Tow-Pro Elite Trailer Brake Controller #RED44FR (version 3) has a smaller knob, adding…

For your 2014 Jeep Wrangler Unlimited with factory tow package, I recommend the Pollak 7- and 4-Pole Trailer Connector Socket w/ Mounting Bracket, Chrysler/Dodge OEM Plug Adapter #HM40975-11933. This kit gives you the wiring adapter you were asking…

Since you have the factory 4-way and the tow package to swap out to a 7-way would only require the part #HM40975-11933. This will install in place of the 4-way square connector and give you both a 4 and 7-way.

For your 2009 Jeep Wrangler Unlimited with a factory 4-way trailer wiring harness the Pollak 7-Way and 4-Way part #HM40975-11933 that you referenced would be exactly what you'd need. This will replace the 4-way you have now and give you a 4-way…

We currently do not have any installation videos for the Redarc Encapsulated Power Diode #RED34FR being used to install the Redarc Tow-Pro Liberty Brake Controller #RED24FR with the Harness #RED69FR and Panel #RED48FR for any vehicles or your 2021…

To add a 7-Way/4-Way combo vehicle connector to your 2017 Jeep JK, I recommend the Universal Installation Kit for Trailer Brake Controller item #ETBC7. The kit includes a pre-wired 7- and 4-way trailer connector that mounts easily at the rear of your…

Hey Danial, thanks for the follow up question! Your 2024 Toyota Highlander will just need the 7-Way Kit #ETBC7 along with the Curt Echo In-Line #C79DR. With this setup you won't be splicing into the stop light switch on your Highlander so even if…

There sure is! The Redarc Encapsulated Power Diode for Tow-Pro Brake Controllers #RED34FR you were looking at gets wired as shown in the included diagram. One of the red wires goes to the red brake output wire on your trailer brake controller, the…

Trailer electric brake magnets are non-polarized. When installing an electric brake assembly, like the Electric Trailer Brake Assembly, Left Hand #AKEBRK-35L, either wire can be used for the brake signal and the ground wire, it will not matter which…

The Redarc Encapsulated Power Diode #RED34FR shouldn't be needed for installing the Redarc Tow-Pro Liberty #RED24FR and Pigtail #RED69FR on your 2020 Subaru Forester. The answer page you're referring to didn't have us telling someone to…

Since your trailer uses a combined wiring system where the stop and turn signals run on the same circuit, in order to add a third brake light to your trailer you would need to use a 2-Wire to 3-Wire Converter, like part #118158. This will convert the…

I recommend the Curt Echo Wireless Trailer Brake Controller - 1 to 2 Axles - Proportional Item #C51180. If the dealership is installing the 7 pole connector, this controller doesn't require any additional wires to be ran inside the vehicle. Your…