Redarc Tow-Pro Liberty Brake Controller Installation - 2014 Ford Van Video

Yes, the Universal Installation Kit for Trailer Brake Controller item #ETBC7 does fit the 2021 Ram ProMaster 1500 so long as you have a 4-way wiring harness installed like the Curt T-Connector Vehicle Wiring Harness item #C58DR. The item #ETBC7 kit…

If you have a vehicle specific wiring harness for a brake controller then that would indicate that you have a factory tow package and subsequently would already have a 7-way at the back of your vehicle. The universal 7-way connector #ETBC7 is meant…

The correct Hayes brake controller install harness that fits your 2015 Ford E-450 cutaway chassis is the part #HA81788-HBC and not the one you referenced as that fits newer models.

The brake controller connector is located behind a panel just to the left of the glove compartment, as shown in the provided photo. The wiring harness adapter used will depend on the brake controller you end up using. I see that you've looked…

To install a brake controller in your 2016 Ford Transit Connect tou will need to start with a 4-way (if you do not have one). For that you would want the #C56218. From there you would need to convert the 4-way to a 7-way so that you can install the…

If the rear bumper of your 2018 Ford Transit T350 doesn't have the cut out portion shown in the picture I attached the Curt hitch part #C13193 will still fit and work well.

I took a look at your order for the Redarc Tow-Pro Elite Trailer Brake Controller #RED44FR, and while it will work with your 2017 Ford E-450 motorhome, it also looks like you have the wrong plug-in adapter. It looks like you ordered the Redarc…

The brake controller you sent in a picture of will only affect the brakes of a trailer you would be towing. It does not affect the brakes of your vehicle in any way if you were to leave the controller installed. I attached an FAQ article on brake…

For brake controllers like your Hayes Lemmerz Energize III part #HA81742B the white wire gets grounded, the black wire runs to a constant 12 volt power source, the red to a wire that only has voltage when brakes are applied (normally on the brake…

I am not sure which Hayes brake controller that you have, but in reviewing the installation instructions for the Hayes-Lemmerz Energize III+ Electric Trailer Brake Controller #HA81742B I found that there is a section that goes over if the…

I have a solution for you, and there are some brake controllers available that can be used with a plug and play wiring harness to ease installation; however the Hayes Energize III #HA81742B is not one of those controllers and it would need to be hard…

Both the Jensen JWM6A and the current model, part #JWM62A are classified as double-DIN head units, which will both use the same sized rough openings in a vehicle dash. The old #JWM6A and the current model #JWM62A both use the same pigtail, as you can…