Rackem Double Barrel Trailer Tailgate Assist Installation Video

The 2K Torque Ramp Spring #RS16933RH is an industrial strength spring. It is designed for up to 90 degrees of deflection, but most people by hand can cause no deflection at all. It is designed to be used with the LH #RS16933LH, and is for heavy…

The Electric Jack part #EJ-3520-BBX is what I recommend using as it's an excellent economical upgrade option. If you are replacing an exiting electric jack then just run the power wire to the battery, secure the flange to the frame, and…

What happens if you attach the quick link to one of the higher holes on the bracket that attaches to the ramp? That should get you more spring tension when the ramp is closer to being closed to help close it.

In order to determine if the Rack'em Double Barrel Trailer Tailgate Assist, #RA-27C, will work with your trailer, you will need to measure the height and length of the side rails. This unit will work on trailer side rails that are 10 to 15 inches…

The length of the spring or internal mechanism does not really matter. What matters is the measurement from the floor of the trailer up to the top of the mounting bracket for tailgate assist #RA-27C. The top of the bracket that attaches to the…

There are a couple of things you will want to check with the installation of the Double Barrel Trailer Tailgate Assist, part #RA-27C. The first thing you will want to check is to make certain the trailer gate does go all the way to the floor with the…

Feel free to send me an email of your setup. But if you can mount the Rack'em Double Barrel Trailer Tailgate Assist #RA-27C 10 to 15 inches higher than the floor the ramp is attached to this should work well for you since it has a 200 lb…

I saw the review you were referencing with regard to the Rack'Em Double Barrel Utility Trailer Tailgate Lift Assist #RA-27C and what they said wasn't that it would not work but that the chain is hindered by the latch. It is possible you may…

I do have a recommendation for you, however, Yakima does not make an adapter for the Yakima HullHound Kayak Saddles w/ Tie-Downs part Y04079 that will allow them to work with the Thule Xsporter Pro Adjustable Height Truck Bed Ladder Rack part…

I have a solution for you. We do not carry hardware kits for the Demco Cast Head Coupler w/ Jack Hole - eZ-Latch - 2" Ball - A-Frame - Bolt-On - 10K #DM37ZR. However the instructions will give you the dimensions you will need and you can pick…

The Demco Cast Head Coupler eZ Latch #DM37ZR coms as the coupler only so you would need to supply the mounting hardware. You will need 1/2" bolts that are at least Grade 5 rated. Anything higher than that will just be even stronger and work just…

The Replacement Square End Cap #853-5826 should work perfectly for you. I went out and measured one and found that it's overall diameter is 2 inch by 2 inch and the inner tube piece measures a tiny bit over 1.75 inches by 1.75 inches so it would…