Trailer Wiring Harness Adapter Installation - 2010 Ford Explorer Video

I am sorry you did not receive instructions for wiring your trailer connector. With the 4-way to 7-way connector you connect the 4-way connector on the vehicle to the back of the adapter. This connection will supply stop, turn and taillights to your…

In order to install a brake controller on your 2007 Ford Expedition you will want to use the Adapter 4-Pole to 7-Pole and 4-Pole part #37185 as this will give you both 4 and 7 way connection points on the rear of your vehicle. The rest of the wires…

How deep is it? It is hard to tell from the picture. You may be able to use some emery cloth and take care of it unless it is too deep. Then you would want to go ahead and replace the axle. Even though spindles are available by themselves you would…

Your 2006 Ford Explorer came with a factory-installed 7-way that uses a round U.S. Car Connector plug at its rear to connect to the vehicle's wiring. We do offer a replacement connector, #HM40975 from Hopkins. Both of these replacement connectors…

The 2010 Ford Expedition should have a round connector at the rear of the vehicle where your 4 pin plug is plugged in. If there is a round connector there you can use the Replacement Multi-Tow 7-Way and 4 Pole Trailer Connector, item #74682, to…

The bolts that you need to install your Demco Hydraulic Trailer Brake Actuator #DM72VR are 1/2 x 4-1/2 inch Grade 5 bolts and it is recommended to use a steel bushing on the interior of the frame to protect it from any over tightening that can damage…

I called my contact at the manufacturer and the connector you sent the photo of sure looks like the mate for the Tow Package Wiring Harness, part #118241. Since the #118241 was designed to fit Explorers from 1995 and up, they may possibly have used…

I do not have any information that is specific to your 2001 Ram, but I can certainly help you through the process. The easiest way to do this is to access the rear of one of your tail light assemblies, as if you were replacing a burned out bulb. Once…

On your 2010 Ford Explorer Sport Trac the factory plug for your brake controller will be located under the dash, on the left side of the steering wheel, just above your left leg. The wiring adapter you will need to connect the Draw-Tite Brake…

If you only need a 5-pin trailer connector for your trailer, then the Tow Ready 4 Pole to 5 Pole Adapter, #20036, would be the easiest option. This adapter plugs into your existing 4-way trailer connector and has an additional blue wire. The blue…

When looking at your 7-way connector from the rear of the vehicle, the pin at the 3 o'clock position is what carries the right turn and brake signal. Start by using a circuit tester, part #PTW2993, to test this pin while someone operates the…

The circuit tester used in the video you referenced, see link, is the Draw-Tite circuit tester, #PTW2993. This tester has a spring-loaded clamp that secures the wire and allows you to easily pierce the wire coating. It does poke a small hole in the…