etrailer.com Trailer Hitch Installation - 1999 Chevrolet Silverado Video

The stock bumper of your 2002 Chevy Silverado 1500 is not a deep drop bumper so the etrailer hitch part #e98849 is a fit for it and would work well.

I did some checking and the only recommended way to tow a 2013 Chevy Spark behind a motorhome would be with a tow dolly like the Roadmaster Tow Dolly #RM-2050-1. There isn't a transmission lube pump available for your vehicle to…

For your 2002 Chevy Silverado you will need to go with a hitch that will fit trucks that do have a factory trailer hitch. For that you would want the Draw Tite hitch part #41944 which will fit your truck once you remove the factory hitch. This…

The main difference between a Class III hitch and a Class IV hitch is the capacities they set for the hitches. Class III hitches are rated for up to 6,000 lbs GTW with 600 lbs TW whereas a Class IV is rated for up to 12,000 lbs GTW and 1,000 TW.…

For trailer wiring the #HM40975 that you referenced would be the correct part to get since it sounds like you have correct harness behind your bumper. This will plug right into it. The harness should have a round connector at the end of it that…

The likely problem is that the weld nuts on your 1999 Chevy Silverado have corrosion and road grime in them and will need to be cleaned out prior to threading the bolts in. This actually comes up a lot on any vehicle that has seen at least one…

The best hitch I'd recommend for your 2011 Chevy Silverado is the Curt hitch part #14301 because it has great towing capacities at 10,000 lb trailer weight and because it has only the hitch tube that hangs below the rear bumper for a more…

A hitch from a 1998 Suburban will not fit a 2009 Chevy Silverado 1500, so you'll need a new hitch; the correct fit is the following: - etrailer Trailer Hitch Receiver #e98849

From the top of the mounting plates to the top of the B&W Heavy-Duty Trailer Hitch Receiver #BWHDRH25124 receiver is a 5-1/4" drop and then from the rearmost bolt hole to the end of the receiver is 10-7/8" (see attached).

The part #HM40975 normally would plug right in to the 7-way wiring of your 2005 Ford F-250, but if for some reason you have a totally hardwired setup your other solution would be to use the part #HM40975-11998 which would allow you to hardwire the…

The Tow Ready T-One Wiring Harness, part #118315, is for the 1988 to 2000 Chevrolet C/K Series trucks. It is not for the 1999 Chevrolet Silverado 1500. The 1999 Chevrolet Silverado 1500 would use either the Tow Ready Wiring Harness, part #118384,…

The etrailer brand #e98849 is a fit for all trim levels of the 2008 Chevy Silverado 1500, including your LTZ. The hitch has a 6000 lb towing/600 lb tongue weight capacity or 10000 lb towing/1000 tongue weight if used with weight distribution. For a…