B and W Companion 5th Wheel Trailer Hitch Underbed Kit Installation - 2011 Ram 1500 Video

Yes, in order to install the Demco Hijacker SL Series 5th Wheel Trailer Hitch part #DM6076SL-16K on your 2004 Ford F-350 you will need to use the Custom Installation Kit w/ Base Rails for Demco Hijacker SL Series 5th Wheel Trailer Hitches part…

When installing the Demco brackets part #DM8553004 a 1/2" drill bit will be needed. The kit comes with grade 5 .50NC x 1-3/4" Hex knurled bolt. I have attached a snip from the installation instructions for your reference but have also…

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

Choosing the right height setting for your 5th wheel hitch is a combination of a few different variables. First of all you want your towing setup to be as level as possible. With your Montana High Country 340BH level you will want to measure from the…

The head alone for the B&W Companion hitch #BWRVK3500 weighs about 70 pounds. Everything else weighs about 130 pounds. So the total weight of the hitch is approximately 200 pounds.

Hi David, Rock Tamers require an inch of space on the ball mount shank in order to mount. If the portion of the shank exposed where you'll be installing the Rock Tamers is 2" x 2" then you'll want #ERT00108, for 2.5" x…

Most fifth wheel rails are made to the same industry standard dimensions. They aren't all though. If you measure 22 inches on center between the two rails and they look like the rails of the #RP30035 that you referenced they would be the industry…

The Ram OEM 5th wheel puck system, shown in the linked photo and article, was launched in 2013 so what you have in your truck is likely to be an aftermarket installation of some kind. These newer Ram trucks with the factory prep can directly accept a…

Hi Robert, To install your Putco Blade LED Tailgate Light Bar #P22KR you'll need to just remove the tail lights so that you can get access to the back wiring in the back of them. The plug-and-play connectors on the wire harness with have a male…

The B&W Companion OEM 5th Wheel Hitch w/ Slider for Chevy/GMC Towing Prep Package #BWRVK3775 you're looking at will work fine with your new Chevrolet Silverado. This hitch has 3 height adjustments so you'll be able to set the hitch height…

To get the B&W Patriot #BWRVK3200 to work with your 2006 Dodge Ram you're going to need a set of 5th wheel rails #DM8552016-71. These rails are custom fit to your vehicle so they'll just bolt right up to the frame. It is worth mentioning…