Front Mount Trailer Hitch Installation - 2005 Toyota Tundra Video

For the Draw-Tite front mount hitch, #65031, the skid plate will have to be permanently removed to install the hitch. You would also need to drill two holes in the frame rails (one on each side for the rear most hitch attachment points). I have…

When installing the CURT Front Mount Receiver, #31180, on a 2006 Toyota Tundra, you will need to drill a total of two 1/2 inch holes. I have included a link to the installation instructions for you. The other hitch we have for your truck, #65031,…

According to the installation instructions, yes, the skid plate does need to be removed in order to install the Draw-Tite front hitch on your 2005 Toyota Tundra: - Draw-Tite Front Mount Trailer Hitch Receiver #65031 I did see the customer photo and…

Both the Curt Front Mount Trailer Hitch #31180 and the Draw Tite Front Hitch #31180 that you referenced would be excellent choices for your 2002 Toyota Tundra. I would probably go with the Curt hitch only because it has been reviewed more times and…

Since we don't have any winch mounting trays that attach to the front of your 2002 Toyota Tundra the best option, we have would be a front hitch like the Draw Tite part #65031 and then using a winch mounting plate like the #BDW20011. The hitch…

On Ultra-Fab trailer hitch #UF35-946403 the brackets that make contact with the frame are 4 inches by 3 inches. The hitch opening sticks out 5-1/4 inches from the main tube of the hitch as well.

For a front mount hitch for your 2004 Toyota Tundra, there are 2 options, see link. Both of them are going to require drilling, trimming, and/or removal of the skid plate for the hitches to fit properly. I would go with the Draw-Tite hitch, #65031…

Unless you drive your Tundra pretty aggressively off-road, I would not be terribly concerned about removing that skid plate. I examined the instructions for the Curt Front Mounted Receiver, and the access hole the instructions refers to is not too…

The biggest difference between the Curt front hitch part #31198 and Draw-tite front hitch part #65080 is that the Draw-tite receiver tube extends out more than the Curt by over an inch. This makes it more visible when nothing is mounted to it.…

I spoke with my contact at Curt about Front mount hitch #31180 for the 2006 Toyota Tundra. He stated that the skid plate does not have to be removed, but there is some trimming of the plate that will need to be done in order to install the hitch. I…

For your 2005 Toyota Sequoia we do have a confirmed fit for your vehicle. I recommend the Draw-Tite Front Mount Trailer Hitch Receiver - Custom Fit - 2" #65031 which will also fit the same model year Tundra. I've attached a video of that…

You are correct that the system that you mentioned, the Hopkins Rear View Camera #HM60195VA is activated when the vehicle is only in reverse. However, you could change the installation a little and connect to the running light circuit. Then as long…