Trailer Hitch Installation - 2005 Toyota Camry Video

Some newer cars, vans and small trucks, especially those with large, aftermarket tires, may require the use of Class S chains. Class S tire chains are designed for use on vehicles with restricted wheel well clearance. I have attached a photo that…

The trailer hitches like the Draw Tite part #36336 fit both a 2000 and a 2005 Toyota Camry as this hitch fits 1992 through 2006 Camrys. I attached an install video for this hitch for you to check out as well.

I would discourage the use of an adapter for use of 2 inch accessories in 1-1/4 inch trailer hitch receivers. The reason is that the adapter places the carrier farther away from the rear of the vehicle and hitch, creating additional torque that…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

To clean the weld nuts to install the Draw-Tite Class II Trailer Hitch Receiver #36336 you'll need a thread tap the same as the M10 fasteners which is 10 mm by 1.25 inches. I've attached a help article and video about cleaning weld…

I have reviewed the installation instructions for the Draw-Tite Class II hitch, part number 36336. There is no indication of cutting the fascia or bumper for the 1999 Toyota Camry. The receiver opening sits flush with the rear fascia or bumper…

Sorry to hear about your car accident and your hitch and bike rack being damaged. As far as installing a new hitch, the first thought that comes to mind is, because of the accident, are all the necessary attachment points for a trailer hitch on the…

There are 2 holes that have to be drilled in the bottom of the frame to install Curt trailer hitch #C12339 on your 2000 Toyota Camry. I have included a link to the installation instructions for you so you can see the installation steps. I have also…

The CE Smith Boat Trailer part #CE48810 would be a great option for your Sportsman AutoPilot 120 as it's 12 feet long like what this trailer was designed to fit and this has adjustable angle and width bunks to best match the hull of your…

The Gordo #HRG2 has a 35 lb per bike capacity and would not be what we would recommend for carrying bikes that weigh over 40 lbs like yours. That amount of weight on a trunk bike rack is asking for a problem. Especially on a long road trip like…

The Yakima RidgeBack 4 Bike Rack part #Y02458 is compatible with 1-1/4" trailer hitch receiver pin holes but only those on a class II hitch. If you have a class I hitch then there could be a stop welded inside the receiver tube which is…

The diameter of the hitch pin hole for the Curt #13241 trailer hitch receiver is 5/8 of an inch. A Pin and Clip, like part #C21500, is designed to fit into the hitch pin hole. You can use part #e98882 for an option that locks.