Correct Thread Tap to Install Draw-Tite Trailer Hitch on 2002 Toyota Camry
Question:
what size tap goes in the 10 mm bolt hole?
asked by: Edward W
0
Expert Reply:
To clean the weld nuts to install the Draw-Tite Class II Trailer Hitch Receiver # 36336 you'll need a thread tap the same as the M10 fasteners which is 10 mm by 1.25 inches. I've attached a help article and video about cleaning weld nuts that you might find helpful as well.
expert reply by:
Charles S
0
Product Page this Question was Asked From
Draw-Tite Trailer Hitch Receiver - Custom Fit - Class II - 1-1/4"
- Trailer Hitch
- Custom Fit Hitch
- Class II
- 300 lbs TW
- 3500 lbs GTW
- 1-1/4 Inch Hitch
- Visible Cross Tube
- Draw-Tite
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Is etrailer Tonneau Cover For 2022 Ram 1500 With 5-1/2 Foot Bed Sturdy & Easy to Remove
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: 4 Lug Trailer Wheel and Tire with Higher Speed Rating
- Article: Ball Mount Basics: Weight Capacity, Class, and Size
- Article: My Trailer Hitch Doesn't Fit
- Q&A: Does Installing a Hitch on a 1999 Toyota Camry Involved Cutting Fascia or Bumper
- Article: How to Choose a Cargo Carrier That Will Clear a Rear Mounted Spare Tire or Bumper
- Article: Trailer Hitch Installation Tips
- Article: How to Clean Weld Nuts for the Installation of a Trailer Hitch | etrailer.com
- Q&A: Tips for Cleaning Weld Nuts to Install Hitch in 2004 Toyota Camry
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Trailer Hitch Recommendation and Towing Capacity for 2003 Toyota Camry
- Q&A: Trailer Hitch for a 1997 Toyota Camry LE