etrailer A-Frame Trailer Coupler - Standard Coupler - CA5400 Review Video

Currently the only way to replace the coupler mechanism on the A-Frame Trailer Coupler #CA-5400-B is to replace the entire coupler. If you are going to do this you should look at changing to the Demco 50-Degree A-Frame Trailer Coupler #12660-97SP as…

I would use a protractor, see photo, place the protractor on the edge of the inside of one side of the trailer frame and the other inside edge of the trailer frame should be parallel with the 50 degree line on the protractor. Another way to verify…

Trailer wiring generally uses 16 gauge wire, part #16-1-1. However, with a long trailer like yours you may want to go with a larger like 14 gauge #DW07550-1 or even 12 gauge #12-1-1. Each size is sold by the foot. You will need to have the lights at…

If you look at the diagram that I received from my contact at Demco, you can see several of the dimensions of the #DM14793-81 trailer coupler. If there were other dimensions you were needing, please let me know.

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

A trailer can bounce if there is not enough weight on it. You see this particularly with utility trailers that are empty. The tire and wheel size would not automatically cause a trailer to bounce though usually you see smaller tires on smaller…

I believe I have a solution for you, but the 27 inch Long Safety Cable #2118-605-04 that you referenced does not have a keeper. Check out the 35 inch Safety Cable #1483-535-04. This is a slightly longer chain, with a slightly higher capacity that…

I looked up your Dexter axle info and you have a 3,500 lb Torflex axle which the part #K71-707-01 would be the correct lift kit for. This will give you a lift of 2-5/8 inches.

In order to upgrade from a 205/75-15 tire to a larger size, the 225/75-15 which is what we offer you will need to account for the reduced clearance. The new size is 1.2" larger in diameter and .8" larger in width but you only need to…

The etrailer A-Frame Trailer Coupler w/ Round Jack Hole #CA-5280-RB uses the standard a-frame angle of 50 degrees. The length from the rear of the coupler to where the coupler meets its narrowest point is approximately 9" long. I have include…

The brake output wire of the jacketed 7-way wiring part #DW04914-1 that you referenced does come with a heavy enough gauge of wire for your brake circuit. The 12 gauge brake output circuit would work well.