etrailer Trailer Bearings Races Seals Caps - Races - 25520 Review Video

The Easy Grease Trailer Idler Hub Assembly for 3.5K Axles part #AKIHUB-545-35-G-EZ-K is a direct replacement for a UFP H-1377.

The Dexter Nev-R-Adjust electric trailer brakes can be manually adjusted. There are a couple teeth of the adjustment wheel that are exposed just under the lever that you referenced. I have attached a photo showing the teeth. You will likely need a…

The brake magnet is held onto an electric braking assembly with a clip. It is not impossible for these to work themselves out over time so I would make sure that you still have the clip in place. The clip is located inside the center of the magnet…

If your trailer has 7 wires running all the way back to the brakes, then yes, you can tap into the existing wiring. Each of your new brakes will have two wires for the brake magnet. One wire is for 12 volt power to the brake magnets and the other…

Thanks for the purchase and if your Electric Trailer Brake Kit w/ Dust Shields #AKEBRK-12 are not giving you full braking, even with the brake controller all the way up, you likely have a wiring issue as that is the root cause of most trailer brakes…

You don't have to do an initial adjustment with self-adjusting trailer brake assemblies, and since it's challenging for the reasons you mentioned I don't recommend doing it and personally wouldn't if it was my trailer. Easiest…

Since you said your hub says 8-219 that would indicate that you need the Dexter hub part #8-219-13UC3 as a replacement. This is a hub for higher capacity axles between 5,200 and 7,000 lbs and has a bolt pattern of 8 on 6-1/2 inches.

The dead trailer battery will not have an effect on the trailer brakes. The trailer brakes get their power and braking signal directly from the tow vehicle and not the battery on the trailer. Though the brake assembly is self-adjusting, it can…

I have included a link to a video on adjusting self-adjusting brakes. Basically there is a device on the adjustment wheel on these brakes that prevents the shoes from adjusting back inward. You have to sort of move that out of the way to be able to…

Yes, you can swap out the grease cap of the Dexter Hub part #8-219-13UC3 to one that has a hole and rubber plug and it would be perfectly compatible with EZ Lube spindles. For that all you'd need is the part #RG04-120 and you'd be set. The…

First I recommend the SumoSprings Trailer Helper Springs #SS26MV be added to your axles. As these are designed for a single axle you will need 2 of the kits. It seems strange that the springs would be damaged as they are not that old and are likely…

We do not carry a tool that will help install your races, though I can pass on some information for you that might be helpful. To install your races, this is what you'll want to do, according to our help article on replacing bearings, races and…