Info for these parts were:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Videos
Help Articles
Expert Answers
The Dexter Electric Trailer Brake Assembly - 12-1/4" - Left Hand #23-428 is just one left hand brake assembly; the other side is the Dexter Electric Trailer Brake Assembly - 12-1/4" - Right Hand #23-429. That is for one axle, and you can…
view full answer...We do have a replacement for Nationals part number 473336. It is our Grease Seal - Double Lip #RG06-050. It comes in a two pack. It has an inner diameter of 1.719 inches and an outer diameter of 2.565 inches. I have a review video down below of the…
view full answer...It is certainly possible for any axle to wear out enough over time to need replacing. Since the suspension is built into a torsion axle if the suspension part was to wear out pretty much the only solution would be to replace the axle. If the…
view full answer...Yes, the Dexter 8k hub/drum part #8-218-9 could be used to replace the hub you mentioned #8-285-9UC3.
view full answer...The Dexter Spindle Nut #6-183 used with your 50mm Nev-R-Lube bearing #31-71-3, requires 145 to 155 ft/lbs of torque, according to the manufacturer's specifications. See attached diagrams for step by step instructions.
view full answer...There is a specific procedure for replacing the #31-71-3 Nev-R-Lube bearing, and it is permissible to re-use the spindle nut. The procedure follows below, and I'll also email you a .pdf copy. Jack up the trailer and remove the wheel, then…
view full answer...I spoke with my contact at Dexter regarding the Nev-R-Lube Bearing #31-71-3 that you will be replacing. He stated that you will just need a 1-1/2 inch socket for the 1.42-1.44 inch nut. This is the same size socket needed for a standard spindle nut.
view full answer...I have confirmed with my contacts at Redline and the manufacturer of this bearing is indeed made by Timken, and that is what you will receive when ordered. This bearing fits the Dexter 50mm Nev-R-Lube axle with 8-lug, 6-1/2 bolt circle. It is…
view full answer...To replace your Iota IDP-240 you'll want to use the Progressive Dynamics RV Power Control Center with AC/DC Panel and Converter/Smart Charger #PD4560K18LS8. This panel is rated for 50 amp service, can provide both 120v/240v and is compatible with…
view full answer...We do have the Dexter Electric Brake Kit part #23-105-106-09 which is 2, 12 inch brake assemblies that can be mounted with a 4 or 5 inch bolt pattern. The 4 bolt pattern that is found on AL KO trailer axles.
view full answer...The Lippert Components Lead Leg Repair Kit #LC146059 and the Stromberg Carlson Kit #LG-146059 referenced in your question are essentially the same kit. I went out to our warehouse to verify this. It is actually not too uncommon for landing gear…
view full answer...The Trailer Hub and Drum Assembly - 8,000-lb Axles - 8 on 6-1/2 - Oil Bath #8-285-10UC3-A is the replacement option we have. The only difference is the wheel studs are 5/8 inches instead or the 9/16 inch wheel studs of your current hub. This comes…
view full answer...