Review of Rackem Tools - Landscaping Tools - RMBS2 Video

Justin, Thank you for the photo. You can use the Rack'em Multi-Mount Grass Catcher - Aluminum and Stainless Steel part #RCMMS4 with the Rack'em Face Plate part #RMBS2 for the Hustler Raptor SDX according to Rack Em. There will not be any…

For your Dixon Ultra 52 you would need the Rack'em Grass Catcher for Toro, Bobcat, and Exmark Lawn Mower #RCMMS4-EXS1 with the bracket kit part #RB-FPEX and you'd be set.

Yes the Rack'em Multi-Mount Grass Catcher #RCMMS4 does fit your 2018 Snapper 360Z as I was able to find pictures of the discharge opening and found that it's a compatible design with this. I attached an install video for this for more info…

We have a couple of options depending on your deck. While the Rack'em Multi-Mount Grass Catcher part #RCMMS4 is part of it you need the face plate to match. If your Toro uses the Z-Cut deck use the Rack'em Grass Catcher for Toro Lawn Mower…

Based on my research your Toro mower does have a standard deck, so you do have the correct grass catcher: - Rack'em Grass Catcher for Toro, Bobcat, and Exmark Lawn Mower #RCMMS4-EXS1

So normally for a Wright Stander mower you'd want the RackEm grass catcher part #RCMMS4-BS2 and for the Toro 52 grandstand you'd want the #RCMMS4-EXS1-TORO. What you could do is use the #RCMMS4 which fits both as the main catcher assembly and…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

You are correct that this refrigerator does not have an ON/OFF switch or function. The best you can do is "Standby" that draws an unknown amount of power. One option is to pull the 12-Volt fuse at the RV power center. A much better option…

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…