Review of Lippert Replacement In-Wall Slide-Out Controller - LC211852 Video

Yes, according to the manufacturer, Lippert, the Lippert Replacement Controller for In-Wall Slide-Out #LC211852 (13398-DO) does replace the 13398-C2.

You can flat tow vehicles with automatic transmissions with tow bars like the Roadmaster Nighthawk part #RM-676 that you referenced but not every vehicle has the same procedures and restrictions. I am not sure what vehicle you have but if you pull…

The Roadmaster Nighthawk, part #RM-676, is one of the nicest tow bars on the market. The tow vehicle will track right behind the vehicle as you are traveling. Since the front wheels of the vehicle will be unlocked the vehicle will steer itself in…

I spoke with Lippert and was able to determine based on the parts listed from Grand Design for your 2022 Grand Design Reflection 303RLS 5th Wheel Trailer that the Lippert Replacement Controller for In-Wall Slide-Out - V-Sync II - Version C2…

The Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Touchpad and Remote - 6-Point Set #LC675817 does require adequate power to work properly. I recommend checking your ground connection from your battery to the trailer frame and…

The "external sensor" error you're getting on the display of your Lippert leveling system like the Ground Control #LC358590 indicates an issue with the rear leveling sensor. This particular sensor should be located a few…

Sounds like you might have an out of stroke error on your Lippert Ground Control system that you need to clear. This is pretty easy actually. To clear the error you need to extend all of the jacks in the system at least 6 inches. Then press and…

Thank you for the picture of the module your Lippert Ground Control kit has as I can tell from it that you have a 4 point kit. So for a replacement control module you'd want the part #LC304136. The "points" refer to the…

I don't know if I fully understand your question about the Lippert 13398-C2 in wall control. I see that you located theLippert #LC211852 - the current replacement for this part. You state that you want to reset the controller using a button…

If you have the factory auxiliary switch then just wire the Custom Third Brake Light Camera for 8" Factory Monitor - Night Vision #3460001 to that. If you don't have the factory auxiliary switch then you will want to utilize that…

I have attached for you the installation manual of the Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System part #LC675817. This is a generic install manual that can be used on any trailer but there is not a set of instructions specific…

It sounds to me like you either have a wiring issue, which could be just a lose connection or kink/damage to the wire, or the slide controller is going out and will need to be replaced. I would first check all your wiring and ensure there…