bing tracking image
Q & A Icon

Troubleshooting Lippert 6-Point Leveling System Reset After Stored Without Power  

Question:

Let stored with out power,supplied power,leveling system was beeping and screen only displays dark boxes can still use the buttons

0

Expert Reply:

The Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Touchpad and Remote - 6-Point Set # LC675817 does require adequate power to work properly. I recommend checking your ground connection from your battery to the trailer frame and then also check your fuses on the control module. The screen being blank sounds like a power issue and beeping indicates you need to reset/recalibrate the system due to that lack of power. The beeping is telling you the zero point needs to be reset.

To do this follow these steps:

1. Turn “ON/OFF” button “OFF”.
2. Push “FRONT” button 10 times.
3. Push “REAR” button 10 times.
4. Control will flash and beep, LCD says “ZERO POINT CALIBRATE”.
5. Manually operate the jacks to attain unit level condition (use carpenter’s level).
6. To memorize this level condition , press “ENTER”.
7. LCD says “ZERO POINT STABILITY SUCCESSFULLY SET”.
8. The control will then turn off.
9. Turn “ON/OFF” on to commence operation.

If this doesn't solve your issue, let me know and we can continue to troubleshoot.

expert reply by:
0
Jason S

James H.

5/12/2020

Question- I just purchased a 2015 Heartland Road Warrior 5th wheel - the trailer had been sitting unused for a year so the battery was dead and once recharged- I have been trying to figure out how to reset the auto leveling system because I can’t read the display - the display just has a bunch of symbols - no words. Please help!

Etrailer Expert

Chris R.

5/15/2020

You might try unhooking the system from power , letting it sit for a bit, and then hooking it back up to tray and reset everything again. Also make sure that battery is in good condition - I know it's been recently recharged but it's possible it was depleted enough to cause damage and require a full replacement. If the jack system doesn't receive enough power it can lead to issues like this.

Robert

4/5/2020

It was ped off brand new from the dealer the driver ped the front legs down and they were put down uneven by him to start the slots or holes were put down one at 6 holes and one at 9holes and he pushed auto level it didn’t level them it read error left jack but I cleared that and now I can operate the system but one front jack is higher than other and it needs to be straighten out it’s leaning to one side It was wrong what this driver did and I gave him 50 dollar tip and everything I try I can’t get it leveledWe bought it from George’s RV in Virginia on I 95We werent even shown where tv remote was kept oh and we can’t get the stove lit eitherWe will be reading a lot

Chris R.

4/7/2020

I'm really sorry to hear about this. I really think you need to contact the RV dealer to tell them what is going on - they should be able to walk you through the operation of the leveling system. For proper leveling you'll just need to set the Zero Point, which is outlined by Jason above.

Robert H.

4/3/2020

I’m at end of my rope with trying to level this dam trailer I just bought a brand new Montana no one showed me a dam thing on how to operate anything and it all starts with this wonderful leveling system with nothing to show me how to get it out of errorBe great if someone knew how to operate this thing

Chris R.

4/5/2020

I can certainly try to help! Can you tell me a bit more about the error message you're receiving? Are you able to operate the system at all or is it completely locked out?

Product Page this Question was Asked From


Q & A Icon

Continue Researching

See More Q&A Expert Answers >>