Review of Lippert Replacement Head Pin for Solera Power Awning Gear Drive Head - LC93FR Video

If you are referring to the head pin then yes we do have this available as the Replacement Head Pin for Solera Power Awning Gear Drive Head part #LC266141. That said, you would also want two Replacement Retaining Clips part #LC266137 and one…

The Regal Drive Head #LC53TF is a little skinnier and doesn't have a logo while the Plain Drive Head #LC273478 is a little wider and has the LCI logo on it (see attached).

You are correct. The Replacement Head Pin for Solera Power Awning Gear Drive Head #LC93FR is the exact replacement for the bent pin on your Solera awning.

To remove the old pin you'll need to remove the cover, remove the two retaining pins, and then slide the old pin out. To install the #LC93FR you'd just reverse the process.

Not quite, there is an additional screw below the wax screw in the end cap that also must be removed on the Solera Power Awning Idler Head #LC672052. From here you can remove the roll tube from the drive head. After the drive head is removed, there…

We have the exact parts you need for your 2021 Palimino Puma. You are looking for the following: 3 x Replacement Retaining Washers for Solera Pitch Arm Assembly #LC431583 1 x Replacement Pitch Arm Assembly for Solera XL 63" Flat Awning Support…

The Replacement Head Pin #LC266141 is for a plain Solera awning system while the Replacement Head Pin #LC93FR fits the Regal Style Solera awning system. I'm not sure what Solera awning you have on your 2016 Keystone Passport Ultra Lite 2920BH but…

Since you were looking at the Regal style idler head #LC672052 I'm assuming you need to replace the idler head pin on your Solera awning. You can remove the old pin and install #LC27WD for a replacement. If by key you mean a cotter pin, then yes…

The pin you need for your Solera Power Awning Drive Head is part #LC266141. The Replacement Drive Head Gear Kit #LC353964 does not include the pin so you need to use the part I mentioned above. Please note that when I reached out to my contact at…

Most slides have EPDM rubber roofs but because EPDM is rubber it requires treatment each year to keep it soft and prevent shrinkage. You could replace it with TPO which is another synthetic rubber that will last longer than the EPDM. The smallest…

The replacement pin you need is the part #LC93FR.

I spoke with Lippert, and they informed me that for your Lippert awning you are going to need the: -Replacement Gear Pack for Lippert Solera Awning Motor #LC78VR, with the Replacement Head Pin for Solera Power Awning Gear Drive Head #LC93FR.