How to Remove and Reinstall New Pin Solera Pin LC93FR
Question:
On the Q solera Awining Head with a bent pin was stated you can not buy the pin alone. That is not correct part Lc93fr. I would like to see how to change the bent one..
asked by: Stuart J
0
Expert Reply:
To remove the old pin you'll need to remove the cover, remove the two retaining pins, and then slide the old pin out. To install the # LC93FR you'd just reverse the process.
expert reply by:
Jameson C
0
Products Referenced in This Question
Replacement Drive Head Pin for Solera Power RV Awnings - Regal Style - Qty 1
- Accessories and Parts
- RV Awnings
- Head Parts
- Hardware
- Solera Replacement
- Head Pin
- Lippert
more information >
Product Page this Question was Asked From
Replacement Idler Head for Solera Power RV Awnings - Regal Style - Black
- Accessories and Parts
- RV Awnings
- Head Parts
- Standard Head
- Head Assembly - Power
- Solera Replacement
- Idler Head
- Black
- Lippert
more information >
Continue Researching
- Q&A: Replacement For A Solera Awning Idler Head With A Bent Pin
- Q&A: Is Solera Awning Head Opposite of Power Head on Awning Setup
- Q&A: Installing a 4-Pole Trailer Connector at Rear of 5th Wheel for Towing Boat Trailer
- Q&A: Replacment Motor for Pump Assembly on Lippert LCI Pump 650057
- Q&A: Replacing Idler Head Pin on Solera Awning
- Q&A: Correct Gen-Y Pin Box to Replace a MORryde RPB72-1716
- Q&A: Replacement Arm for Solera 3000 on 2023 Salem Hemisphere Elite 36FL
- Article: How to Install an RV Awning From Scratch
- Article: RV Sway Control, Stabilization, and Suspension Enhancement
- Article: Replacing RV Awning Fabric: Your Step-by-Step DIY Guide
- Article: Tire TLC: How & When to Check Your RV/Trailer Tire Pressure
- Article: RV Roof Types: What Type of Roof Does My RV Have?
- Article: Trailer Wiring Diagrams
- Article: Double-Eye Trailer Suspension System Review