Fulton Trailer Bearings Races Seals Caps - Caps - F001526 Review Video

I reached out to my contact at Dexter and for a replacement stud compatible with the Dexter Trailer Hub #K08-426-91 you have you will need the #7-122. This will be slightly longer than your current studs but all of the other dimensions are the same.…

The Dexter Wheel Bolt #7-262 that you referenced is indeed extremely close to the measurements on your existing bolt and it should work great as a replacement. This is the closet option we have available. I did also go out to our warehouse just to…

I was not able to track down specific information regarding the studs for your existing hubs, but if you have a 5,200 to 6,000 pound hub with the 6 on 5-1/2 inch bolt pattern you mentioned, you will likely need a 1/2 inch drive-in stud. If your…

It is likely that you are looking for Dexter Wheel Bolt #7-262; these have a thread diameter of 1/2" and are 2-11/16" long. I have added a link to a video review of this part for you to take a look at as well.

You are correct that all bolt-on trailer jacks require a square or rectangular frame member for installation. There is no bolt-on jack made for a round tube trailer frame since this would make securing the jack rather difficult; it would want to…

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

The number you provided, "7753400" is a patent number which corelates to the Equalizer for E-Z Flex Suspension part #013-144-03. This is for a single equalizer but if you need the entire kit it's the Dexter E-Z Flex Suspension Kit part…

For your enclosed trailer application I have several suggestions for adding interior lighting that you can control directly via a switch. Since your current 4-pole trailer wiring does NOT include a 12V auxiliary power feed that could power inside…

The only way you could power interior dome lights on a trailer without it being connected to a tow vehicle would be to power the lights with a battery like a breakaway battery. How you choose to wire up the batteries will in the end be up to you, but…

Assuming your Sprinter has the factory tow package with the 7-way at the rear bumper, in addition to the #RED24FR Redarc Tow-Pro Liberty Brake Controller, you'll also need the #3063-P wiring harness and the #331-TPH-017. The connector to install…

The modern size equivalent of the 20.5x8-10 that you have currently would be the same size tire that is on the #AM3H340 that you referenced, 205/65-10. As long as the bolt pattern of your current hubs are 4 on 4 inch the wheels of this would bolt up…