Curt Gooseneck - Below the Bed - C60713 Review Video

The B&W Heavy-Duty Trailer Hitch Receiver #BWHDRH25122 that will fit your 1986 Chevy K20 will measure 5.438" from the top of the frame brackets to the top of the receiver. If this is looking like it will not be enough to clear the…

The distance from the center of the front hole to the center of the rear hole is 17-3/16 inches, and then the distance from the center of the rear hole to the middle hole is 5-3/4 inches.

I have attached an image of the Draw-Tite Ultra Frame Trailer Hitch Receiver #41947 referenced in your question with a few dimensions labeled. The distance between mounting holes, from the left side mounting bracket to the right side mounting…

The #BWHDRH25122 has 35-5/8 inches between mounting holes like what you see in the picture I attached. Since you need larger than than let me know what vehicle you have and I can see which would be best fit.

The horizontal mounting plate that mounts to the frame of your vehicle on the #41947 is 2-13/16" wide and the mounting plates themselves are 11-9/16" tall. The holes on the horizontal mounting plates are 3/4" and 1-1/4" in…

I called my contact at B&W and she gave me the following measurements of their Class V Trailer Hitch #BWHDRH25122. From the rear bolt hole to the middle bolt hole is 11-3.8 inches. From the middle bolt hole to the front bolt hole is 5-15/16…

The B&W Heavy-Duty Trailer Hitch, part #BWHDRH25122 is designed to fit a 1995 GMC C/K Cab And Chassis pickup. This hitch will fit pickups with a 34 inch frame and will not work on trucks that have dual fuel tanks. I pulled one of these from our…

Since your 2008 Ford F-350 is a Stake Bed Truck you will need to look at the trailer hitches that fit an F-350 Cab and Chassis. I have linked our selection for you to filter through. The most popular choice is the B&W Heavy-Duty Trailer Hitch…

I went out to the warehouse and pulled Curt Class V Trailer Hitch #C15300 and took some measurements for you. From the front bolt hole to the rivet (center to center) is 1-5/16 inches. From the rivet to the rear bolt hole is 7-7/8 inches and the…

On B&W trailer hitch #BWHDRH25122 the mounting brackets are oriented the same for all applications. The tabs point in but attach to the bottoms of the frame rails. The customer submitting photo appears to have some other component installed. The…

The best solution we offer is the Draw-Tite Ultra Frame Service Body Trailer Hitch Receiver #41990-07 will fit the frame width you have and the drop requirement you need as well. It does require some fabrication to install like you mentioned which…

I am unfamiliar with the Barden Bumper and in my research, I could not find any specific information regarding the Barden Bumper. Our trailer hitches are not tested with aftermarket bumpers. We have two bumpers that have been determined to be a fit…