Customers compare C17057 to these similar products
Products Featured in this Video
Hi there, I'm Michael with etrailer.com. Today we're gonna take a quick look at this CURT MV Weight Distribution System. We're gonna go over some of the features and compare it to some of the weight distribution systems that we have available here at etrailer.com. So, from the start, I will let you know this is a very basic system. There are other systems out there that have a lot more advanced… see more >
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Videos
Help Articles
Expert Answers
Yes, the 921 LED Bulbs #ARC48FR would be a compatible replacement for a JRP1007B light bulb. With this light being LED it will have a lower wattage and amperage draw for a cooler, brighter light that requires less energy to run.
view full answer...Most weight distribution spring bars are about the same length. Typically they are either 29 or 31 inches in length. The spring bars of the Curt #C17062 would be 30-5/8 inches, and the bars of the #PS49583 would be 31-1/4 inches.
view full answer...Weight distribution works to distribute the tongue weight of a trailer up to the front axle of the tow vehicle so that it will sit more level and handle/brake better. That being said the systems do not "reduce" tongue weight or allow you to…
view full answer...Thank you for sending the photos they are very helpful. Based on the measurements in your photos, I think the Reese Strait-Line Weight Distribution System with Dual Cam Sway Control, #RP66075, will work for you. The snap up brackets should fit…
view full answer...There is a way for you to determine which Equal-i-zer system is the right one for you but you will need to know your tongue weight with water and the amount of weight behind the rear axle of your truck. From what you described, if you loaded the…
view full answer...The distance from the center of the coupler to the center of the sway control arm should be 19-3/8" for overslung couplers which you can see in the photo attached below. In regards to the sway control cam bracket, the hole size is indeed…
view full answer...I went out to the warehouse and measured Replacement Cap #MJ-1500B-CP for you. The threaded part has a diameter of 2.08 inches. The overall diameter is 2.19 inches. I have included a picture showing these measurements.
view full answer...The spring locks for the Blue Ox weight distribution systems are the all the same but the attachment points are different. The only replacement option is the Replacement Spring Lock Kit for Blue Ox 2-Point Weight Distribution Hitch Head item…
view full answer...The oblong holes are a no go, the spring bars will eventually fall out of the socket and the system would be completely ineffective as well as a danger to those around you. Also, if you are loading your trailer to the max then the system you have now…
view full answer...The factory installed trailer hitch on your 2010 Lincoln Navigator is indeed rated for use with weight distribution. The hitch itself is rated for 9,000 pounds gross trailer weight when used with weight distribution. However you will be limited to…
view full answer...A Reese weight distribution system is going to have a tongue weigh capacity range. The 1,200 pound systems are rated for 600 to 1,200 pounds of tongue weight. The tongue weight will increase once you load the trailer. But, you also have to add the…
view full answer...The only other extension that will meet your 36" requirement is the Titan Hitch Box Extension for 2-1/2" Trailer Hitches, 41" - 48" Long #RP45018. This extension would have a maximum gross trailer weight of 7,500 lbs/750 lbs of…
view full answer...