Review of Bearing Buddy Bearing Buddy - Bearing Buddy Bra - BB19B Video

Bearing Buddy pumps grease into the center of the hub all the way back to the grease seal. A double lip seal should be used to prevent grease from blowing out the seal when added. When the hub and seals and bearings are first assembled, they should…

The Replacement Bearing Buddy Bras Model 17B, part #BB17B, will fit on Bearing Buddy grease caps for hub bores from 1.781-inches to 1.810-inches. These caps will have an outer diameter of close to 2-inches. Because these bras are made of flexible…

Your Magic Tilt boat trailer uses UFP hubs and bearings. In my research I found that your spindles are compatible with the L68149 inner and L44649 outer bearing and the 10-19 grease seal. For the proper replacement hub, use #AKIHUB-545-35-K which…

Based on the diameter of the Bearing Buddy that you measured the correct replacement bra or cover is the part #BB19B you mentioned.

It really just depends on what you are looking to get out of the bushings. Bronze bushings, like part #K71-291-00, will last longer but are more noisy and it is recommended to use wet bolts like part #126B2 to keep them lubricated. Nylon bushings,…

The term, wet, in this case means that the head of the bolt has a grease Zerk in it and there is a channel that leads to center of the bolt. This makes it easy to grease the bolt while installed, as you can put a grease gun right up to the Zerk and…

We do have a compatible grease seal for your 168255TC oil seal, however, we do not carry rubber coated seals in this size. The 168255TC oil seal was designed to work with oil bath hubs on a 3,500 lb axle. For the most part, axle manufacturers have…

A trailer that is over 80 inches wide is required by DOT regulations to have rear clearance lights. An over 80 inch taillight kit, like part #TL16RK, will have the side clearance light built into it. An under 80 inch taillight does not have the…

I spoke with my contact at Kodiak and he said that yes you can turn the disc brake hub/rotor to remove the rust and pits. Etched into the backside of the rotor there will be a minimum width clearance or minimum rotor thickness that you can turn to.

The maximum speed rating for trailer tires is 65 MPH. The B rating is the load rating for the tire, which is 590 pounds at 65 PSI. You always want to have the tires of your trailer inflated to the maximum PSI rating at all times. If they are not…

Your math is correct in your trailer weight load example. If a fully-loaded tandem axle trailer weighs 4000-lbs then each of the 4 tires will bear 1/4th of that load, or 1000-lbs. In this case a tire rated for 1300-lbs would provide a good safety…

You will most likely need to use a 1,000LB spring like either the Double-Eye Spring 26" #e77SR or 20-3/8" #e53SR. It is important to match the springs as close as possible to the weight of the trailer and the cargo without exceeding the…